subject: The introduction about Light [print this page] The introduction about Light The introduction about Light
Light or visible light is the portion of electromagnetic radiation that is visible to the human eye, responsible for the sense of sight. Visible light has a wavelength in a range from about 380 or 400 nanometres to about 760 or 780 nm,with a frequency range of about 405 THz to 790 THz. In physics, the term light often comprises the adjacent radiation regions of infrared (at lower frequencies) and ultraviolet (at higher), not visible to the human eye. where to buy cheap LED Strip? Lightereryday is a good choice.
Primary properties of light are intensity, propagation direction, frequency or wavelength spectrum, and polarization, while its speed, about 300,000,000 meters per second (300,000 kilometers per second) in vacuum, is one of the fundamental constants of nature.
Light, which is emitted and absorbed in tiny "packets" called photons, exhibits properties of both waves and particles. This property is referred to as the waveparticle duality. The study of light, known as optics, is an important research area in modern physics.
The speed of light in a vacuum is defined to be exactly 299,792,458 m/s (approximately 186,282 miles per second). The fixed value of the speed of light in SI units results from the fact that the metre is now defined in terms of the speed of light.
Different physicists have attempted to measure the speed of light throughout history. Galileo attempted to measure the speed of light in the seventeenth century. An early experiment to measure the speed of light was conducted by Ole Rmer, a Danish physicist, in 1676. Using a telescope, Ole observed the motions of Jupiter and one of its moons, Io. Noting discrepancies in the apparent period of Io's orbit, Rmer calculated that light takes about 22 minutes to traverse the diameter of Earth's orbit. Unfortunately, its size was not known at that time. If Ole had known the diameter of the Earth's orbit, he would have calculated a speed of 227,000,000 m/s.
Another, more accurate, measurement of the speed of light was performed in Europe by Hippolyte Fizeau in 1849. Fizeau directed a beam of light at a mirror several kilometers away. A rotating cog wheel was placed in the path of the light beam as it traveled from the source, to the mirror and then returned to its origin. Fizeau found that at a certain rate of rotation, the beam would pass through one gap in the wheel on the way out and the next gap on the way back. Knowing the distance to the mirror, the number of teeth on the wheel, and the rate of rotation, Fizeau was able to calculate the speed of light as 313,000,000 m/s. recommend directory: 1M 60LEDS SMD3528 LED Light Bar.
Lon Foucault used an experiment which used rotating mirrors to obtain a value of 298,000,000 m/s in 1862. Albert A. Michelson conducted experiments on the speed of light from 1877 until his death in 1931. He refined Foucault's methods in 1926 using improved rotating mirrors to measure the time it took light to make a round trip from Mt. Wilson to Mt. San Antonio in California. The precise measurements yielded a speed of 299,796,000 m/s.
Two independent teams of physicists were able to bring light to a complete standstill by passing it through a Bose-Einstein Condensate of the element rubidium, one team led by Dr. Lene Vestergaard Hau of Harvard University and the Rowland Institute for Science in Cambridge, Mass., and the other by Dr. Ronald L. Walsworth and Dr. Mikhail D. Lukin of the Harvard-Smithsonian Center for Astrophysics, also in Cambridge.
where 1 is the angle between the ray and the surface normal in the first medium, 2 is the angle between the ray and the surface normal in the second medium, and n1 and n2 are the indices of refraction, n = 1 in a vacuum and n > 1 in a transparent substance.
When a beam of light crosses the boundary between a vacuum and another medium, or between two different media, the wavelength of the light changes, but the frequency remains constant. If the beam of light is not orthogonal (or rather normal) to the boundary, the change in wavelength results in a change in the direction of the beam. This change of direction is known as refraction.
The refractive quality of lenses is frequently used to manipulate light in order to change the apparent size of images. Magnifying glasses, spectacles, contact lenses, microscopes and refracting telescopes are all examples of this manipulation. recommend directory: Waterproof IP68 Aluminum Shell SMD 5050 LED Light Bar.
