subject: Constructing an Interior Stone Wall [print this page] Constructing an Interior Stone Wall Constructing an Interior Stone Wall
Felt paper, metal plank, mortar and stone facing are the most crucial materials for the construction of the interior stone wall. The advancement in technology has made it possible for manufacturing plants to produce synthetic stones, which contain organic mineral oxide colors, lightweight stone particles, cement amongst other chemically produced products.
The construction of the interior stone wall begins with the assembling of all the building materials. This is followed by measuring the entire top part of the wall, which will be covered. In your calculations you need to deduct the section where you will not apply any stone this would include the doors and windows on the wall. In order to avoid any accidents as you begin your interior stone wall construction, it is crucial to disconnect a used circuit breaker before removing any outlets or switch covers, only then can you remove the light switch and outlet covers as well as the wall trim.
When mounting the interior stone wall on to spotless and unprocessed masonry surfaces or concrete it can be done without placing a moisture wall or metal plank. However, when working with drywall material you are required to get the surface ready. This preparation begins with covering the wall with plastic canvas or felt paper to produce a moisture wall.
Place the plastic canvas one on top of another until you have a width of 4 inches then firmly join them on to the wall using a stapler gun. The plastic canvas placed on top of the surface should be covered with a metal plank in order to give it the appropriate mortar grip. Firmly join it onto the wall on the surface where moisture barrier is located by hitting the nails an inch deep inside wall studs. In addition, ensure it has penetrated the wallboard.
Other than hammering the galvanized nails, you can make use of a stapler gun as well instead of the nails. Make sure the staples are placed six inches away from each other. Add some water into the mortar, mixing it constantly until you get the prefect consistency. In order to ensure the mixture for creating your interior stone wall is just right, it should take a short while before it drops down when placed on a trowel facing down.
This mixture is what is applied generously on to the surface of the wall. Give it about 48 hours to allow it to dry out completely. Once all the panels are placed on the interior stone wall, take care to fill out any gaps using some mortar, and then clean off all the excess mortar using a brush. This should be done after about half an hour.
The most believable architectural interior stone wall is a result of refining the art completely to produce interior stone wall over a span of 30 years. Cast from custom molds created from hand-selected natural stones, these interior stone wall panels can be used in kitchens, living rooms and basically any room where you want to use the warmth of real stone to compliment interior spaces.
Interior stone wall creates a relaxing and cozy effect when paired with traditional cool materials like stainless steel and laminated wood. Installing manufactured stone is not only economical at one/3 to 1/2 the price of natural stone; it is lightweight and requires no footings, wall ties or foundations. Interior stone wall per panel weighs only 10 pounds per square foot and can be applied to any structurally sound surface.
