subject: The PS3 YLOD Fixed In Easy Steps [print this page] The PS3 YLOD Fixed In Easy Steps The PS3 YLOD Fixed In Easy Steps
Understanding the way to fix a Playstation 3 at your house is easy. Almost everything through the PS3 YLOD (yellow light of death) on to the red blinking light is attributable to a specific thing; the console getting too hot. After you examine this whole short article you will see precisely why heat screws up your machine and ways to halt and prevent it.
Heat is definitely the top trouble with almost all electronic devices, it is the enemy of electric powered components. An excessive amount of heating could potentially cause equipment to fail and can destroy your machine. Every thing must be kept cool to function correctly, this includes your Playstation 3 system.
Blowers are first in the line of protection vs . temperature. They take cool air in and press heat out, this is the key downside to blowers. There is not any filtration system to stop dirt and crud from coming in to your system. Even though cool air is being driven into the system hairs, dust, airborne debris, and all sorts of other things are brought in as well.
Even while dirt is being blown into the system it becomes caught on all kinds of places. Everything from the system mother board to the tiny components which are soldered on to the main board tend to be places where dust and filth are usually caught. All of this crud collects in the system and will keep it from cooling down, it behaves as a blanket.
When the blowers on your system can not cool the machine itself it is called overheating. Overheating, as I have explained, is actually the principle source of just about all troubles. But, the good thing is that it is a fairly easy issue to repair.
To start with, be sure you have sufficient space round the Ps3 to ensure that ample air comes in. I recommend retaining a minumum of one foot in all directions wide open and free from obstructions. That will permit adequate cool air to come in without it being stopped or heated up by all sorts of things all-around it.
Next, be sure you do not have your Playstation 3 on the floor. Every little thing drops on the ground, from a hair floating in mid-air to dust out of your shoes will end up on to the floor. This will cause grime accumulation and can subsequently cause over heating.
Next, and above all, reopen your console and use a container of pressurized o2 to get all kinds of things out. Blow off the main board, blow out the fans, and blow out any grime or crud you can view. I do this task just about every 8 weeks or thereabouts. This appears to be enough time between cleanings but it really will vary to suit your needs based on your behaviors.
