for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.If the above did not work for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.
Canon PIXMA MP780 All-In-One InkJet issue
If the above did not work for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.
If the above did not work for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.If the above did not work for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.
If the above did not work for you then you have to disconnect the suitable cables and eliminate the Logic Board from the Chassis. Loosen (do not eliminate) the 4 mounting screws (the mounting screws be able to be originate behind the logic board) on the Chassis. Then you have to re-seat the white synthetic direct so it sits flush against the Chassis. The tip of the white synthetic direct is supposed to sit to some extent inside the escalating screw hole. When seated appropriately, the gap determines to no longer be present. After that you have to tighten the 4 mounting screws without causing the synthetic direct to shift. At the end you have to reconstruct the printer and retest.
