subject: The key point of green design [print this page] The key point of green design The key point of green design
Green contouring is about as distinctive as finger prints. Nevertheless, all expert greens should have a extremely important factor in typical. They need to be playable.
We have all encountered putting surfaces which are marginal, and probably even unplayable, but those are the exception as opposed to the rule. While some skilled designers prefer to put most of their movement inside the putting surface proper, other people like to incorporate the movement on the perimeter of the surfaces and run it onto the surfaces. An example of this would be carefully placing mounds around the perimeter of the green and tailing the mounds onto the putting surface. By performing this, you produce some really interesting contours without making use of up too a lot of the cuppable location inside the putting surface. These "tailing mounds" are also extremely helpful in segmenting the cupping areas. An ideal green could be a three lobed configuration with a "tailing mound" separating each cupping region. Each cupping region should offer six or seven cup placements. Balls stopping within the suitable segment really should give a reasonably straightforward putt within fifteen or twenty feet. Balls stopping on the edge of the green or in a distinct segment of the putting surface could call for a double break or putting over a mound. Nothing impossible, but a far more challenging putt.
Multiple-level greens have their place and are really successful when used effectively. They're finest used to counteract a green web site that slopes excessively from back to front. A multi-level green used here eliminates building a putting surface that slopes so severely that players cannot quit a ball close to the cup on downhill putts. It also keeps you from building a 1 level green where the front is built up so high that it looks fully un-natural. The secret to developing a functional multi-level green is within the transition between the platforms. Numerous of the older multi-level greens use way too a lot of the putting surface inside the transition between levels. It is not unusual to see as significantly as a third or half of a green un- cuppable as a result of the transition slope.
It is critical, in the course of the initial grading of a multi-level green, to over exaggerate the slope between the two levels. It's also critical that the slope between the levels be flat and not convex or humped. As the green is built up with the different rock and leading mix layers, the slope begins to mellow. What was previously a severe slope is now significantly more acceptable.
Right after the top mix has been installed, the designer need to work with the superintendent to figure out the final contouring, so as to avoid scalping the crown when grass is established.(http://topgolfclubs.net/)
