Board logo

subject: Get Familiar With How To Deal For Magnesite Flooring [print this page]


It is simple to mix up magnesite with a pigmented sand/cement screed; however the following functions can aid recognition. Magnesite flooring surfaces is electronically conductive and so an electric level of resistance wetness gauge will provide a complete range wet studying even when the content is cuboid dry. Also, a little group when organized in gas fire will shine really brightly, like a gas layer at the sides.

The composition of these floors is magnesium oxide combined with a strong solution of magnesium chloride to form magnesium oxychloride. This binder can be combined with sand, gravel and dye to form what appears to be a colored concrete floor. Or when marble chips are added will resemble Terrazzo. Magnesite flooring is porous and will stain. Therefore, they must be enclosed. However since mineral magnesium oxychloride is sodium, they cannot be washed or enclosed with any content that contains detergent, or the ground will convert white-colored. If there is any question about the ground, you should check a small area first.

Magnesite flooring is a floor leveling and sound attenuating medium that was applied as a topping to floors in the 70s and 80s. In service it has been revealed that in contact with moisture it produced a weak solution of hydrochloric acid due to the presence of chlorides in the magnesite.

Over a long period of time the solution migrated through fine cracks in the concrete and acted on the reinforcing steel causing corrosion and subsequent expansion product of corrosive steel causing the concrete to delaminate and spall from the substrate. This in effect caused structural damage to the slab in that the effective area of reinforcing steel was reduced and the protective cover layer of concrete was damaged.

The source of wetness to start this process is most generally found in wet areas of the models or close to exterior surfaces where water infiltrates through the surfaces, Microsoft windows or entrances onto the ground.

Following a review of the current report made the decision to carry out detailed investigation of each floor on a progressive basis.

Select a floor for investigation.

Bring out the research perform using the support of a restorative works specialist to assess in details the location and level of damage and the restorative perform needed.

During the research if the restorative performs in a device was found to be minimal then conduct the restorative performs instantly. If the suggested restorative perform was significant to the level of resulting in interruption to the habitants then the area was momentarily reinstated and the suggested perform was then put into a discussed designed for the perform to be performed at a appropriate time in the future.

During the research process as models opportunely became available due to rental or possession changes, the research perform was performed and any restorative perform needed performed instantly while access was available.

So, these are all about the Magnesite Flooring. Means, how it comes and how it works and how it is dealing.

by: John Gorman




welcome to loan (http://www.yloan.com/) Powered by Discuz! 5.5.0