subject: Must Follow Safety Tips While Using Aluminium Loading Ramps [print this page] There are a number of industries that use the loading ramps on a regular basis. Some of the industries where this is a common sight is the manufacturing industry, construction industry, shipping industry and even the automobile industry. As the name says, the aluminium loading ramps are ramps that are made of this metal and are used to load or unload heavy products from trailers and trucks. These ramps provide the easiest ways to load heavy equipment such as the skid steer, fork lift, tractors and more onto large trucks or trailers and transport them to their destination. Considering the weight of these machines, it is impossible to carry them manually. The ramps are designed to simplify this task and automate it. Digga ramps and those from a few other notable manufacturers of heavy duty machinery are in high demand. However, irrespective of the ramps you purchase, it is important to adhere to a few safety measures to ensure no unfortunate accidents occur at the work place.
The first safety tips that you should follow while using the Digga ramps is to keep the ramp angle to a minimum. More often than not, it has been noticed that people place the ramps at an incline while loading or unloading heavy vehicles or machines. This is definitely not a right move since it increases the chances of an accident. The best option is to ensure the aluminium loading ramps are almost at a parallels to the surface. This is possible only when the truck or trailer is placed at a lower level as compared to the loading ramps.
The next safety tip is to drive in reverse in case of a rear wheel drive. Loading a front wheel drive vehicle onto the trucks using the Digga ramps is relatively easier as compared to loading a rear wheel drive. Vehicles such as tractor have a lower centre of gravity as compared to bikes which have a higher centre of gravity. Therefore, the risks of loading the latter are higher when compared to the former. The chances of overturning and tumbling to the ground are high while loading a rear wheel drive. The best way to minimise this and enhance the safety is by loading it in reverse over the aluminium loading ramps.
Another important safety tip is to avoid using the Digga ramps when they are wet. aluminium loading ramps that have moisture do not offer sufficient traction, thus increasing the chances of the vehicles slipping down easily when they are being loaded or unloaded. Hence, it is imperative to either wipe it dry with a clean absorbent cotton cloth or place it out in the sun for a few hours before putting it to use. In addition to this, make sure that the safety chains that are provided with the ramps are always securely fixed in place and the wheels of the ramps are locked to prevent the ramps from sliding down during the course of the task.
