subject: The Importance Of The Proper Use And Maintenance Of The Ups Power [print this page] The importance of the proper use and maintenance of the UPS power
Use UPS Batteries & Power Supplieshttp, we generally just do it in accordance with the instructions of the steps, www.ibuonline.com remind you, but also to learn more about the use of knowledge in the proper use of a UPS power.
Select UPS Batteries & Power Supplies installation location
A good installation location is very important to place the UPS place must have good ventilation, away from water, flammable gases and corrosive ambient temperature is maintained at between 0 ~ 40 at low temperatures disassembly may there will be water droplet condensation phenomenon. Once the ambient temperature is more than 25 degrees, every 10 degrees, the battery life will be shortened by half. Currently used by the UPS power batteries are generally maintenance-free sealed lead-acid battery design life expectancy is five years.
UPS power supply placement
UPS power supply should not be side should remain unobstructed air intake hole and out of the wind hole; load and UPS power connection must turn off the load, re-wiring, then open each load, non-electric, copiers and other inductive loads access UPS power in order to avoid injury. UPS power supply is connected to a dedicated outlet with overcurrent protection device, the power outlet should be connected to protective ground terminal; regardless of the input power cord is plugged into the City, an electrical outlet, the UPS power output may be energized. To make UPS power output must turn off the switch, and then cancel the mains supply.
To prepare Real-Time Video Equipmenthref=http://www.ibuonline.com/category/Video-Equipment
The intelligent UPS power have the the operable performance characteristics of computer communication and program control. Install the appropriate software on the PC, UPS power supply through serial / parallel port connection, run the program, you can use the computer and UPS power to communicate. General information query, parameter settings, timer settings, automatic shutdown and alarm functions. Such as Winpower. Then through a dedicated serial control cable, the UPS power supply connected to the computer, UPS power supply the City electrical input and low battery shutdown function can be achieved through both RS232 and RS485 protocol communication. And it can simultaneously monitor multiple UPS power connection on multiple serial ports. Through RS232 protocol, a serial port can only be connected to a UPS through RS485 protocol, a serial port can connect up to 256 UPS power.
Maintenance of the UPS power Lighting & Electricals
Excessive battery discharge and battery is long-term open-idle allows the battery's internal resistance increases, the charge and discharge performance deterioration. For the long idle UPS power, reboot before use, so draw a line load in the charging circuit charging the UPS power use within 12 hours after the best every month so that the UPS power backup UPS power in the inverter state for 2 to 3 minutes, to activate the battery. In addition, there is a need to strictly control the battery charging current must not exceed the maximum charging current of the battery allows. Because excessive charging current will result in shorter battery life.
Do not use diesel generators to charge
UPS power should not be powered by a diesel generator mutates frequently, because of its frequency instability, affecting the normal operation of the UPS power.
