subject: Directions For Replacement Screens For Psp 2000 [print this page] The PlayStation Portable 2000 (or "PSP Slim") incorporates a large LCD screen which is not protected between uses. A cracked or damaged LCD screen has to be replaced if the PSP 2000 Housing Case is to carry on being used. You'll be able to replace the LCD screen with one purchased from the PSP supply store, although this will void the Sony warranty. The treatment for replacing the LCD screen is straightforward and require any electronic skill. You'll have your PSP Slim all set within the hour as opposed to needing to lose time waiting for so that it is repaired in a service center.
1. Put a soft cloth on a table. Put the PSP facedown for the soft cloth using the disc-drive door towards the top middle edge facing from you.
2. Take away the battery-compartment lid from your left side of the PSP along with your fingers. Pull the battery out of the battery compartment with all your fingers.
3. Get rid of the three screws from inside from the battery compartment with all the Phillips jeweler's screwdriver.
4. Fling off the warranty sticker inside the battery compartment using the tip of the screwdriver.
5. Utilize screwdriver to take out the screw that's hidden within the warranty sticker.
6. Use the screwdriver to remove the screw on the bottom middle edge of the PSP.
7. Use the screwdriver to get rid of the screws from both sides with the disc-drive door.
8. Turn the PSP face up around the soft cloth with all the disc-drive door facing clear of you.
9. Offer the PSP down while using right. Pull the faceplate from the PSP while using left hand.
10. Insert the tip of the screwdriver under the black metal bracket in the bottom inside edge of the PSP. Wiggle the end of the screwdriver to loosen the black metal bracket. Do this again procedure on the right side with the bracket.
11. Grab the left side on the black metal bracket with all your fingers. Pull the bracket out in the PSP 2000 Repair Parts with your fingers.
12. Utilize the tweezers to get rid of the cable from the motherboard which is connected to the black metal bracket.
13. Rotate the PSP in order that the disc-drive door has become facing you.
14. Insert the end with the screwdriver beneath left side from the LCD panel with the center with the PSP. Wiggle the end from the screwdriver to loosen the left side on the LCD panel. Repeat this procedure around the right side from the LCD panel.
15. Lift the LCD panel from the PSP along with your fingers. Using the tweezers eliminate the cable on the motherboard which is coupled to the LCD panel.
16. Put the LCD panel on the soft cloth.
17. Release the tumble each party of the LCD panel with the tip on the screwdriver. Slide the LCD sieve from the LCD panel. Discard the LCD screen.
18. Remove the protective plastic from either side on the replacement LCD screen. Slide the replacement LCD screen into the LCD panel. Reengage both latches using the tip from the screwdriver.
19. Plug the cable on the LCD panel in to the motherboard when using the tweezers. Squeeze LCD panel back for the PSP. Push down within the LCD panel along with your fingers.
20. Rotate the PSP in order that the disc-drive door is facing from you. Plug the cable from the black metal bracket to the motherboard while using the tweezers. Put the black metal bracket into the PSP with your fingers.
21. Placed the faceplate back onto the PSP 2000 Case. Turn the PSP over. Reattach the screws. Squeeze battery back in the battery compartment. Placed the battery-compartment lid back onto the PSP. jklzaeqc 1029
