subject: Methods To Tie Reinforcement In Detroit Steel Beams [print this page] Detroit Steel Beams have a horizontal structure when present in a building. Beams are made up of many materials such as timber, steel, wood, etc. Steel beams are used to carry the load of the building and provide support to it. Beams are usually spanned from one row or column to another row or column. They are of different sizes which depend upon the load to be carried and the design of beam. These beams usually come in shapes such as rectangle or square. For reinforcement purpose concrete is used to make the Detroit Steel Beams a structural member of the building.
Reinforcements that are used for the structural members are mostly round bars. The bars should not have any rust earlier than its use on work of the site. The wire that is tied on the steel bars in the round manner must be cut into lengths. Bench is used for tearing the reinforcements. The same bench is used for bending the reinforcements. When straight runs are made then the bars are measured along the full length of beams. They are then allowed to bend from the ends of it. The rings that are used are cut in square or rectangular shape depending upon the shape of the reinforcement that is used in the building and hence when such measures are taken the performance increases on a whole.
A reinforcement of the beam is done which is just a sample and it is of 5 meters in length. The beam should be of two millimeter by three hundred millimeter in size which should be done accurately and without committing any mistakes. It should use bars that are twisted and having a size of 16 and 12 millimeter. These twisted bars must be used on the top as well as the bottom side also. The bars that are four in number are measured out to be 5 meters each. An extra twisted bar of 120 millimeters is fixed at both the ends. The total length of the rings is calculated and they are then given the shape of a rectangle. Such measures must be done accurately and precisely so that there is no fault and the whole building gets firm support. If measures are taken correctly then it ensures that the building will not collapse at the time of any disaster.
Detroit Steel Beams must be checked and measured whether the finished beams are in the correct measurements or not. The rings must be enclosed with firm concrete at all sides to make it rock solid.
