subject: Gasification System- A New Means Of Renewable Energy In Our Daily Lives [print this page] You might have heard about the term Gasifier and you may think that it is such a complex meaning as even the usage of this term would also be quiet difficult. But this is not the case and the process through which biomass gasification system is conducted is not very complex and it is with the help of highly structured and highly skilled and durable machines that this process is used. These machines are known to be our right hand in todays competitive world. These machines are quiet eco-friendly and also help to provide a green and clean environment. It can be used as an alternative to greenery.
It is very important to have an alternate source of energy so as to make the environment clean and green. This process of gasification where the screw press is used is known to be one of the most powerful sources of technology so as to produce green energy. The bi-products of this process are known as wood gas and syngas that are known to be a solid form of biomass and it is found in the gaseous form. It also has a number of particulates and tars.
In the industrial cleaning systems a scrubber is used as it is known to be a proven method that is used to remove 99% of particulates and around 60% of tars. The inlet gas stream that is used enters the converging section and then the area decreases along with the velocity of gas with time. The liquid that is then developed in the main mode of the product has a converging section that is attached along with it from where the inlet gas is pushed at a high velocity where the liquid element is also used in it for the converging section.
The process of gas removal is an important process as it combines the fog present in the tiny liquid droplets. The process of particulate removal increases along with the level of pressure that is used on the gas velocity and it can be operated with the pressure drops that are in the range of 12-250 cm. In the scrubbing systems also the dirty water is thrown as it has a lot of tar content.
The alternate source of energy where screw press is used should not be wasted and should be used to generate maximum efficiency so as to offer higher levels of productivity. If it has to be removed then it can be done in a secluded area in any industry where this process can prove to be quiet helpful.
