subject: The Common Types Of Dryer Lifting Plate [print this page] The common types of dryer lifting plate The common types of dryer lifting plate
Dryer is a drying machine with large handling quantities of material. The material are evenly distributed in the cross section of the drum and well contact with the various parts of the drying medium; there is a lifting plate in the dryer cylinder and the types of lifting plate are the following:
1 A cross-shaped or rack-shaped lifting plate: applying in a small piece of more brittle and easily dispersed material, so that the material can be uniformly dispersed in the entire cross section of the cylinder.
2 Four format lifting plate: applying to high density, coarse or hard dispersed materials. The plate divide cylinder into four forms, appearing mutually unintelligible fan-shaped operating room; materials and hot gas contact surface are bigger than the lifting formula plate, and can increase the rate of filling material, reduce the height of the landing of materials and reducing the amount of dust loss.
3 The sleeve lifting plate: suitable for the duplex heat transfer (or half the diameter of the heat) drum dryer board.
4 The lifting style plates: applying to bulk materials or easy to bond in the tube wall material.
5 Minute format (fan) plate: suitable for very fine particles which easily cause the powder flying materials. The materials deposited on the grid board, when the cylinder rotates, the material flip and continue to be contacted with the hot gas, at the same time, because of the reduction of materials falling height, it reduces the possibility of dry material is taken away by the gas.
The above various forms of lifting plate can be distributed throughout the drum dryer cylinder body, in order to make the material can be quickly and more evenly supplied to board, it is also available to install the spiral-shaped guide plate at the feed end with the 1 ~ 5m to avoid the wet material accumulated in supporting wall.
