subject: Matters Needing Attention In Operating Ball Mill [print this page] First, before starting the equipment, check whether the whole equipment and its key component is good or not; check whether there is loose situation on each connecting bolt of the ball mill; check whether the lubrication of each lubrication point is normal or not; check the transmission and protective equipment; check the electrical instrument and the carbon brush for electric machine, which can ensure the normal work of the ball mill.
Second, turning a week, check the rotation parts of the equipment and check whether there are some obstructions around the equipment or not. If there are, remove them. Note: when starting the equipment, it is not allowed to stand around the equipment.
Third, after checking and ensuring every part of the equipment is normal, can the start button be pressed. Note: when starting the equipment, pay attention to the changes of the current. Hongxing experts remind users that the ball mill can not be consecutively start more than twice. The spacing interval between the first and the second start must be more than 5 minutes. If the third start is necessary, the ball mill must be checked by the conjunction with electricians and the fitters first. Note: the ball mill can not be started with other equipments at the same time. It is necessary to start them one by one, which can avoid the tripping operation happening.
Fourth, when the ball mill is in normal operation, the overloading operation is forbidden. And the idle running time must be less than 15 minutes, which can avoid bunging up the lining plate.
Fifth, in the running process, it is necessary to check whether there is a plasma leakage phenomenon on the cylinder. Check whether the current, voltage, feeding, and the water supply are normal or not. Check the motor per half hours and the temperature of the principal axis should be less than 60. Solving problems must be in time.
Sixth, before stopping the ball mill, the mineral supplying must be stopped first. After finishing disposing the concentrate, stop water supplying. And then, press the stop button and pull down the gates.
