subject: Installation And Operation Of Industrial Dryer [print this page] Rotating dryer can be used for drying many kinds of materials and with convenient and reliable operation; therefore, it has been widely used.
The traditional dryer always heats air surrounding, and transports the hot air to roller around. The humid air resulted in this procedure will be excluded out, leaving dry air to keep drying. The traditional design does not recover the heat, and is therefore very inefficient. However, the traditional design is simple, reliable, and reasonable-priced.
This is a new developing dryer, more advanced than the conventional dryer . Its working principle is not to heat through the hot air. First, the material in roller is heated to 100C, then resulting damp and hot water vapor. After water vapor escaped out of roller, it will be collected and compressed. Under the pressure of tension, water vapor liquefies and produces heat, sending the heat back to roller, by which it can achieve recycling use of heat. The dryer on this technology, with its efficiency reaching double times of the traditional dryer, the drying time can also be reduced to that half of the traditional dryer.
The Installation of dryer machine.
First, when the dryer is transported by the manufacturer to your laundry room, you must first have a routine check. You should check which type of the machine you have purchased and if there is damage in the transportation process, and if the machine can be used. You should immediately take photographs and contact with manufacturers if you find these problems.
Second, before installing the dryer, you should determine the installation location of the dryer. In terms of selection of the dryer installation location, you should take into account the transport corridors, raw material turnover, inflow, inlet and the location of the sewer.
Third, the dryer is a bulky laundry facility with heavy weight, so the machine should be installed on the solid foundation required to maintain the level at the same time to prevent the appropriate selection of the location and uneven from causing large vibration when the equipment is at work, which will affect the service life and the washing efficiency of the dryer.
Forth, you should refer to the instruction manual of the dryer and find the door of the electrical control cabinet of the industrial washing machine in accordance with the instructions. Access to 380V three-phase power line and the zero line according to the terminal mark.
Operation of Industrial Dryer.
First, open the door. Make the material after dehydration evenly rotate in rotating-drum and then close and lock the door.
Second, according to the type of fabric, select the appropriate time and adjust the timing device to the desired time.
Third, press the start button and start the fan. According to users' needs, the direction of rotation of the drum can be chosen as a one-way rotation or bi-directional rotation. You just need to rotate the computer board switch to the one-way or two-way. The machine will perform one-way operation or two-way operation according to the requirements. (Forward 25 seconds, stop 5 seconds, and reverse 25 seconds).
Forth, frequently observe the flip of the internal fabric from the observation window. Promptly cut off the power and check the fault if the accidents are found.
Fifth, when the machine runs to the specified time, the machine will automatically stop running. At this time, the operator should open the door to check the drying situation of the internal fabric drying. If the desire effect is not achieved, you may appropriately extend the time.
Large industrial dryer is a very important process flow in the ore dressing production line. The dryer production line operates reliable, flexible, and adaptability with large processing capacity. It is widely used in the field of metallurgy, building materials, chemicals, coal washing, fertilizer, ore, sand, clay, kaolin, etc.
