subject: To Improve The Production Capacity Of Jaw Crusher [print this page] This article is mainly about the key factors which affects the production capacity of jaw crusher. Generally speaking, there are lots of factors affecting the production capacity of jaw crusher. Roughly speaking, there are five key factors. Now I will cover the five key factors and offer some solutions for them.
1. The Hardness of Material
The harder the material is, the more difficult the crushing process is, and the more serious the wear on equipment is. With hard material, the crusher will have low crushing speed and ability.
2. The Components of Material
The more fines the material has, the more difficult the sand making process is, because it is easy for the fines to influence the transportation of jaw crusher. Therefore, for the material with lots of fines, it is better to sift them in advance. Sifting the fines out can avoid affecting the normal operation of jaw crusher.
3. The Fineness of the Crushed Material
The higher the demand of fineness is (that is to say, the thinner the material is), the smaller the crushing ability is. In general, it is set up depending on the specific requirement and usually, it is set up to the medium fineness for the crushed material.
4. The Viscosity of Material
The greater the viscosity of material is, the easier the adhesion is. It is easy for the material with high viscosity to adhere to the inner wall of jaw crusher. If not clean up in time, it will affects the work efficiency of jaw crusher, even affects the normal operation of jaw crusher. Therefore, it is better to choose the crushing material with low viscosity.
5. The Humidity of Material
When the material contains much water, the material will adhere to the inner wall of jaw crusher easily, at the same time, the blocking will be cause easily in the process of discharging and transportation, which will decrease the sand making ability. For solving this problem, the humidity of material should be controlled strictly. If the crushing material is in large humidity, we can use the methods of sun exposure or air drying to decrease the percentage of moisture in materials.
in large humidity, we can use the methods of sun exposure or air drying to decrease the percentage of moisture in materials.
