subject: Battery Discharger [print this page] Battery was designed to test the effectiveness of the vacuum for all kinds of effort, and batteries and capabilities.
These instruments perform a controlled discharge of the battery, while the current is kept constant by converting a high DC / DC frequency, based on MOSFET technology for smaller units and IGBT technology for large units.
Landfill operation is completely automatic: simply connect the battery to adjust the voltage cut-off, and the maximum current at the time of discharge. All tests are carried out automatically, while the digital display shows the partial results of the discharge.
KEY FEATURES BATTERY spark gap
1. Electronics and the protection of polarization reversal arc (no valves). The active circuit prevents the bending between conductors when you connect the battery. If the battery is connected with reverse polarity, the device does not begin and current flows.
2. Self-test power. When the operating system discharge, and are tested for self-control and power electronics in less than 10 seconds. In case of failure of an item, and the vacuum is in a safe position existing before.
3. DataLogger integrated. While the amnesty is in progress, it is not necessary to leave the computer connected permanently to the alarm, because the datalogger has sufficient memory to store the entire discharge curve. At the end of the test, it is possible to load data from memory to vacuum your computer in seconds. Interface is a standard USB connection. Wireless interfaces are available on request.
4. The scope of analytical capacity, with the computer. It is powerful, and custom software that extends the capabilities of. It offers the possibility to generate plots for different discharge curve: The battery voltage, discharge current discharge energy, [kW], and the ability to discharge [him], and energy discharged c.
5. Parallel process is limited, controlled by the program. When two or more of the units operating in parallel, it is possible to download all the data with the software, and integrated into one report complete test. This feature gives the possibility to reach a discharge power is limited, by linking an unlimited number of units at the same time.
Operating sequence
1. Make sure your computer is not connected to a serial port or USB vacuum battery;
2. Connect the battery to be tested;
3. Turn on the camera, by moving the key 0-1 to put "1";
4. The screen will display the battery voltage for 3 seconds, then displays the proposed power cuts, with a flashing message "U";
5. If necessary, adjust the tension off with the + and - buttons, then click on it to ascend;
6. The screen will display the maximum time allowed for the test, with a flashing "H";
7. If necessary, adjust the maximum allowed to test with the + and -, and then click on it to ascend;
8. Vacuum and BDX are now ready to start the test. It will appear on the screen is "ready."
9. Press both the + and - buttons together to start the test.
If the key is set 0-100% at zero, the system discharges start the test, and appears on the screen of discharge current in amps. At this point, the use of all controls and 0-100% + / -5% to adjust the discharge current to the desired value.
If the knob 0-100% non-zero position (all left), and the drainage system does not start and displays on the screen "pot." It is necessary to convert the voltage 0-100% left to position zero, then the battery starts BDX vacuum.
Company that manufactures electrical equipment for measurement and maintenance of power stations offers customers reliable equipment. We have a wide range of products such as the liquidation of the resistance measuring device, power analyzers, and discharging the battery, transformer test equipment or test equipment for the relays. For more information about the test breaker, please visit our website.
