subject: Use High Pressure Water Cleaning To Remove Just About Anything Anywhere [print this page] High pressure water cleaning is a new tool for cleaning in construction. Some use it for masonry work. It can clean new brick while also helping with restoration work. Some systems can also help clean the mess up afterwards. This is great for the removal of hazardous material. The water helps keep the particles out of the air. Then the vacuum process removes it before it dries up. The water is then passed through a filtration system that makes the hazard material solid waste. This method is many times faster than traditional hand removal of these materials. Some common things to be handled are lead paint, carpet glue and mastics made of asbestos. All of this poses danger if inhaled. This process eliminates or reduces this danger.
For pools that need to be resurfaced, high pressure water cleaning can make it easy to remove the surface. The results are a pile of dust that can be easily be cleaned up and disposed of. And in the process, the surface is made ready to receive the new coating on top. This same system can be used on just about any concrete surface. It can remove unstable bits that could be hazardous. And the high pressure water will score the surface to receive the next coat. It will not fracture the surface underneath like a hammer could. It prepares the surface with less manual labor than traditional methods.
Vertical surfaces are just the right challenge for high pressure water cleaning. Since they do not allow liquids to sit, getting a vertical surface prepped can be very time consuming. This system makes this easy. The high pressure blast will remove most anything from the surface. Waterproofing and mastics don't stand a chance in the face of this blast. A surface can be quickly prepared for just about anything. And it can be done by one person in an amazingly short amount of time.
Marine coatings are also an easy challenge for high pressure water cleaning. These surfaces are treated to withstand exposure to salt water and the elements. They can be very tough to remove. But a high pressure blast of water can safely knock away just about anything on these surfaces. It is a good way to prevent exposure to the chemicals in these coatings. The water removes it and that can be filtered to prevent seepage into the ground. All of this means better safety but efficient removal of what you want gone.
