subject: A Brief Introduction To The Spiral Classifier [print this page] The spiral classifier is one of the numerous water conservancy classification equipments, a kind of mechanical classifier with the structure of elevating and conveying desilting. According to the spiral numbers, it can be divided into two types, one is single-spiral classifier, and the other is double spiral classifier. According to the height of the downflow weir, it can be further sorted into high weir type, low weir type as well as immersed weir type. As for the specification of the spiral classifier, it can be presented by its spiral number and the spiral.
Structure
It is composed of a U trough, spiral, transmission, elevator machine, support bearing etc. The downflow weir of the high weir type is higher than the lower bearing, but lower than the upper edge of the lower spiral. There is a horizontal long axis with helical blades in the U trough, and a downflow weir designed in the lower place. The transmission is installed in the upper chute, the upper main spiral shaft supports the bearing on the drive frame, while the lower bearing is fixed at the level of the elevator. The elevator is able to make the lower part of the spiral ascend and descend to regulate the distance between the spiral and the bottom of the chute as well as the confirming size of the spiral. Meanwhile, the spiral should be raised up at the time of a stop in order to avoid the desilting burying the spiral that will impinge on starting. The bearings of the main spiral shaft are quite vital parts, due to relatively harsh working conditions, the requirements for the sealing of the bearings are high. At the same time, the operator must strengthen the maintenance.
Working principle
Ore pulp is fed into the U chute from the middle feed opening on the side of the chute, along with the spirals low-speed rotation and unremitting string of the ore pulp, most of the light and fine particles suspend on the surface then overflow from the downflow, those particles are called overflow products; some coarse and heavy granules will settle down to the bottom of the chute, pushed to the upper of the chute by the helical blade and then discharged, the dehydration is completed during the conveying process. If the desilting enter the mill for another grinding, then the desilting is called sand return.
Stone crusher : http://www.crusher-export.com/hammer_crusher.htm
Cement making machine : http://www.best-crushers.com/cementmill.htm
