subject: The Reasons Why Every Homeowner Wants A Solar Panel Home [print this page] The rising cost in household expenditures particularly with the monthly power usage is leading a lot of homeowners to switch to solar panel home. DIY solar panels are remarkably simple to build and may be a big help in saving plenty of money compared to purchasing pre-made units. The solar panel system assembly and installation can be a big savings when you use a solar panel kit. The package will supply instructions to construct your own PV modules at home.
Your solar panel home will contain solar cells, the major component to turn sunlight into electricity. When these cells are used together and assembled into panels, they can generate different amounts of voltage and current based on how you are going to connect them. It's essential that you understand the kind of power that you will need before you can proceed with the construction of your panels.
You will find two fundamental kinds of solar cells which you can use in your solar panel home. One kind is the monocrystalline solar cells that provide the highest degree of efficiency and are considered to be usually the most reliable. Nonetheless, these could be a little more costly when compared to the other kind. There's the polycrystalline solar cells. They have a lower cost however the bad thing is that they often lag behind the other in terms of effectiveness. That's where you should decide. Will it be quality over price?
Solar cells should be effectively connected to be able to generate the proper voltage and current for the solar panel home. With your solar panel kit, you can see that wiring diagrams are already included and it's important that you follow these closely. Ensure that the cells are mounted on a piece of thick plywood and should face exactly in one direction. The dimension of the backing board is determined by laying out the cells as shown in the diagram. You can start soldering the wires to the cells once they're already mounted. Secure the wires neatly on the backing board so that they will not obstruct when the cells are exposed to sunlight.
Whenever you are finished, you can take your solar panel home outside to verify the voltage using a voltmeter in order for you to see that everything is working properly as it should be. Whenever you have difficulties, you need to check again the wiring. Complete the panel by attaching the cells with a glue on the middle to the backing board. Place enough caulking to enable the wood to expand or contract due to heat. You can then put the covering using plexiglass to avoid water from entering the panel and to stand against other weather conditions.
The best part where you can place your solar panel home is where there's plenty of sun exposure. The panel will produce DC electricity that can be utilized to charge batteries and power smaller appliances. When you require AC power, you have to connect the solar panel system to an inverter in order that other devices could work inside your homes.
