subject: Large Ball Mill In The Continuous Development [print this page] Large ball mill in the continuous development_Ivylm522LCXK instrument is used to measure and control the pendulum to the measurement of the feeder device computing systems.
1. The instrument applies to the following control system.
Discussion with Mr. Shaw: simplify, tense, first person, rationality, or personal characteristicsDosing machine
By controlling the feeder belt speed to control the feed flow.
2With pre-feeder belt weigher
By controlling the pre-feeder to adjust the belt load to control the feed flow.
3Belt weigher
Belt speed and ball mill belt load, calculate the flow rate and volume of feed.
2.The front panel diagram:
1. Display:
16 16 dot matrix LCD backlit display, 2 lines, character height of 6mm.
Upstream left of the display: Run information
Right: set the feeding unit is t / h
The left side of the downstream monitors: Event Information
Right: choose the actual flow, belt load and belt speed
If the LCD screen is not jaw Metallurgy Rotary Kiln crusher clear, adjust the potentiometer of the upper-left corner of the LCD screen.
2. Semaphores:
The two green LED lights and 3 red LED lights.
Green light: Operating ready
Red light: the failure or limit beyond information.
3.Key
Flexible film can touch the keyboard.
Key Description:
Display parameters are defined:
Flow rate = feed rate of the actual value of the unit: t / h
- The amount of material per unit time through the belt.
Speed ??= speed jaw crusher of conveyor belt unit: m / s,
Load = belt load unit: kg / m
Load code = load sensor signal conversion code number:
Temperature = instrument internal temperature Unit: C
4.Instrument works:
Weight: Control the way.
Volume of work: non-control mode.
Note: The "" on the left side of the upstream monitor, indicating that the volume of work, "" show that the weight work.If no, the meter is in control.
