loan

subject: The Ball Mill New Control Strategy Research [print this page]

The ball mill new control strategy research_Ivylm522 The ball mill parameter is the soul of the instrument, instrument parameter changes to adapt to a variety block machine of external devices, so a deep understanding of the meaning of each parameter is a good instrument to deal with different scene Key.

Mounted instrument factory default parameters, the user is applied to each individual device, you should adjust the corresponding parameters to accommodate the equipment.Parameter

There are two ways one is in the calibration procedure is automatically placed in one is manually placed in the meaning of each parameter is as follows:

1. P flow display the number of decimal places

Range: 0 to ball mill 5

Note: display the parameter setting the number of bits, the integer part, fractional part, and not more than six.More than six decimal places

Decrease automatically.

Default: 2

2.P 1 rated the feeding

Range: 0.0 to 1500.0

Dimensionless: t / h (t / h)

Default value: 10

3.P 2 load display the number of decimal places

Range: 0 jaw crusher to 5

Default: 2

4.P 3 rated belt load

Range: 0 ~ 1000.0

Description: No placement, determined by the rated flow and rated speed.

Dimensionless: kg / m (kg / m)

jaw crusher Default value: 27.78

5P 4 speed display decimal places

Range: 0 to 5

Default value: 3

SaturdayP 5 rated speed

Range: 0 to 10

Dimension: m / s (meters / second)

Description: The belt speed value determined by the parameters in the speed sensor, invalid.

Default value: 0.1

7P 6 zero value (tare value)

Range: 0.0 ~ 999,999.0

Dimensionless: kg / m (kg / m)

Description: In addition to the results of skin procedures, automatic deposit.

Default value: 0.0

8P 7 calibration weight weight

Range: 0.0 ~ 999,999.0

Dimensionless: kg (kg)

Description: weight weight must be placed and matches the weight of calibration weights.

Default value: 10

9P 8 Metallurgy Rotary Kiln flow rate correction factor

Range: 0.0 to 10.0

Note: the formula: P8 (new value) = P8 (original value) weight value / total value (the same

P36)

Or P8 (new value) = P8 (original value) deviation (KOR)

Default value: 1.0

10P 9 speed sensor?

Range: 0 to 1

Description: 0 Invalid speed sensor, speed is determined by the P5,

ball mill A speed sensor input.

Default: 1

11P10 load sensor load

Range: 0.0 to 1000.0

Dimensionless: kg (kg)

Note: The total load capacity of the load sensor.

Default: 60

(Source: mill www.xbm-mining.com The)

by: Ivylm522

welcome to loan (http://www.yloan.com/)