subject: House Frame Inspections [print this page] This particular article will specifically focus on the house frame inspections, the particular time and manner in which the relevant authorities conduct it. To conclude the article, a few tips will be highlighted on how to improve your house framing details so as to improve your chances of passing the framing inspection.
Most municipalities call for all contractors to undergo a chain of inspections before they are permitted to construct homes in their localities. These series of inspections help to certify that the contractors always stick to the area building code. One of the key inspections conducted during the construction process is the house frame inspection. This inspection is usually conducted halfway through the construction process.
Time And Manner In Which It Is Conducted
The initial house frame inspection is routinely undertaken after other sections of the construction have completed and satisfied the building department review. In most cases this type of inspection is carried out after the footer, electrical and plumbing inspections are done.
The following fundamentals of construction have to be observed before any framing inspection is embarked on:
- Completion of the installation of basic cabling, pipes, ducts and vents
- Withholding of the cable insulation procedure and fixing of interior wall finishes till the framing inspection is complete.
Once on site, the building department inspector first determines if the construction meets all the requirements of the building code. He then ensures that all previous necessary inspections have been conducted and that the contractor has satisfied all prerequisites. The building department inspector also sees to it that the rough cabling and plumbing work do not distort any framing elements. The attaching of the framing and the minimum ceiling height must also adhere to protocol. The inspector finally evaluates if the staircases have been installed properly and verifies that the walls, floor and roof have all been framed appropriately.
Tips for Improvement
Contractors have to always ensure that they observe the proposed plans certified by the municipality. Failure to observe them will automatically lead to failing the inspection. The following tips can therefore be applied to enable you and your structures pass the inspection:
- Proof check the minute specific such as ensuring that the suitable hardware and fasteners are on point.
- Have with you any tags or documentation pertaining to prior assessments available to the inspector for perusal.
- Verify that all framing work in progress is well supported by braces until they are steadily attached to other sections of the structure.
- Despite the fact that 2" x 4" planes are normally used for interior framing, 2" x 6" planes will form bulkier walls that allocate for more space for plumbing and improved sound insulation.
- Finally, when choosing wood for your house framing, steer clear of boards that are either warped or twisted. These kinds of boards tend to pop up challenges in regard to finishing of the walls with drywall. Boards with modest to miniature fault can always be cut down for bracing or be utilized as makeshift cripple studs.
