subject: How to Upgrade a HP DV6000 Laptop [print this page] If your HP Pavilion dv6000 laptop is running out of storage space or isn't running programs as fast as you'd like, it may be time to consider an upgrade. The HP Pavilion dv6000 laptop is sold with a 256- 512- or 1-GB 667 DDR2 667-MHz SDRAM memory module, but is upgradeable to a 2-GB memory module. The laptop comes standard with a 2.5 inch 5,400 RPM 60-GB ATA-5 laptop hard drive and can be upgraded using any 2.5 inch ATA-5 laptop hard drive
Upgrade tough Drive
1
Turn off the HP Pavilion dv6000 laptop and unplug all of the cables and wires and devices connected towards the laptop.
2
Close the laptop's monitor, then lift the laptop up and place it upside along on a flat surface area to ensure that the back side of the laptop is closest to you.
3
Push the battery-release latch, situated above the correct side of theHP DV6000 Laptop battery, towards the right to disengage the battery in the HP Pavilion dv6000 laptop. Lift and remove the battery.
4
Rotate the laptop so the side that opens is closest to you.
5
Remove the two screws in the bottom of the tough generate cover, situated inside the lower-right corner of the HP Pavilion dv6000 laptop, making use of a Phillips screwdriver. Lift and remove the cover.
6
Grab the pull-tab toward the back of the tough generate bracket and pull the bracket back to disconnect the tough generate in the laptop.
7
Lift and remove the tough generate bracket.
8
Remove the six screws along the edges of the tough generate bracket that maintain the tough generate inside the bracket, then remove the aged tough generate in the bracket.
9
Place the new tough generate inside the bracket and replace the six screws that maintain the tough generate inside the bracket.
10
Set the tough generate bracket inside the lower component of the tough generate bay and push the bracket up to connect the tough generate towards the HP Pavilion dv6000 laptop.
11
Place the tough generate include back on the tough generate bay and replace the two screws that fasten the include towards the HP Pavilion dv6000 laptop.
12
Rotate the laptop right up until the battery bay is closest to you, then slide the battery into the battery bay right up until it clicks and locks into place.
13
Turn the HP Pavilion dv6000 laptop right-side up.
Upgrade Memory Module
1
Follow actions one through 4 in Section 1.
2
Remove the two screws inside the bottom of the memory module cover, situated inside the middle of the laptop, then lift and remove the compartment cover.
3
Push the clips on the short sides of the memory module away in the module. The memory module will tilt upward.
4
Lift and remove the aged memory module and slide the new 1 into the slot.
5
Push the memory module down, creating the clips to proceed back in toward the module and lock into place.
6
Place the include on best of the memory module bay and replace the two screws to fasten it towards the HP Pavilion dv6000 laptop.
