subject: Fault And Processing Method That May Occur [print this page] Fault and processing method that may occur
1. Discharge of material moisture content is too high. Should increase fuel use while reducing the volume of feed.Discharge of material moisture content is too low. Should reduce the amount of fuel used while increasing the volume of feed.This operation should be gradually adjusted to the appropriate state. The adjustment willresult in the discharge of water containing fluctuated significantly, to reach the product quality requirements.
2. Two block rounds of force. This phenomenon should check the roller and the wheel bearing with the exposure. The same set of supporting roller is not parallel or two supporting roller connection with the cylinder axis is not perpendicular, will cause the gear wheel is too large, but also caused the occasional round of normal wear and tear.
3. This phenomenon is often low installation accuracy or bolts loose from its normal position in the occasional round of work due to Recovery care to turn to the right place, this phenomenon that is able to disappear.Operation issued by the size of the gears isnot a normal voice. These should check the size of the gear meshing clearance. Appropriate adjustment that is able to return to normal.Pinion badly worn should be replaced.Gear cover seal to prevent dust from entering the lubricant adequate, reliable lubrication is the key to improve the service life of gear. Heavy duty gear oil or black oil should be added to the gear cover.
For more information ,please visit our site as follows:
