subject: Improvements Of Lubrication Oil Station [print this page] Improvements of lubrication oil station Improvements of lubrication oil station
1. Improvement of control system
The original thin oil station detection pump pressure to control their work status. Petrol stations equipped with three pressure gauges, oil pressure, filter pressure, oil pressure. Pressure changes can only indirectly reflect the flow changes, the flow does not necessarily increase the pressure increases, the control flow is the most direct and effective. Especially in the winter the temperature changes due to downtime and operation of each mill should start to adjust the valve to supply pressure of 0.2 ~ 0.4mpa, but is also growing with the growth of the running time of lubricating oil temperature, viscosity constantly decline, with the attendant pressure is also reduced.
2. The transformation of two high-pressure pump
The ball mill typically use the "static pressure to start the hydrodynamic lubrication" of the way. Before the start of in the ball mill, first by the high pressure pump to the hollow shaft and bearing between pump into some of the lubricant between the shaft and tile formation of a layer of film, reducing the starting resistance. A few minutes later the ball mill operation, high pressure pump to stop working. The lubricants rely on the rotation of the ball mill to form a "hydrodynamic lubrication".
3. The improvement of heat exchanger
The heat exchanger is to protect the ball mill operation in the summer safety facilities. Thin oil station originally attached to the heat exchangers and tube heat exchanger. This heat exchanger is large volume, low efficiency, cleaning is very difficult to scale, leakage repair more difficult. We use a plate heat exchanger to replace the original tube heat exchanger, to overcome the shortcomings of the tubular heat exchanger.
The heat exchanger is to protect the ball mill operation in the summer safety facilities. Thin oil station originally attached to the heat exchangers and tube heat exchanger. This heat exchanger is large volume, low efficiency, cleaning is very difficult to scale, leakage repair more difficult. We use a plate heat exchanger to replace the original tube heat exchanger, to overcome the shortcomings of the tubular heat exchanger. The grinding end lubrication oil station than the heat exchanger area of the wheel head lubrication oil station 2m2, because the grinding end lubrication oil station addition to the need to take away the heat generated by bearing friction, but also taking the ball inside the material through the hollow shaft part of the conduction heat.
