subject: Puzzle Of Energy-saving Ball Mill Get Solved [print this page] But faults and problems that may arise in the course are more or less same. Next, we look at some details of the maintenance of energy-saving ball mill:
A month to check first liner wear, and timely attention to the replacement of anti-wear cylinder.
Note that the oil fuel supply, lubrication not allowed intermittent, and control the bearing temperature shall not exceed 60 degrees Celsius.
(3) reducer, main bearings and lubrication of the drive gear. We recommend using hl-20(winter) or hl-30 (summer use) gear oil.
Should be selected to manipulate, maintenance and inspection of the mill work and performance of personnel familiar with.
Normal work of all institutions and device (motor, reducer, etc.), the oil supply can supply enough fuel before the start of the machine must be confirmed.
The mill in accordance with the specified direction of operation, or can not discharge or cause damage to the machine.
4 mill is not allowed to overload and work for inadequate material circumstances.
(5) should be periodically quantitative complement the maximum size of grinding media to the tube into the hole (one week about time)
6 monthly intervals to check the first liner fastening to prevent the liner off.
Cooperative Bank in order to reduce the interval time should always be equipped with a full set of easy to wear.
Mill every good seal.
The lubricant should regularly filter (available 2-3 layers of gauze)
Special attention to routine maintenance, the machine should be put into productionmachine maintenance program, and effective and strict implementation of this plan, thus ensuring the machines often work in normal circumstances, its greatest efficiency and extending its life in order to improve efficiency play a multiplier effect.
