subject: Surefire Rc Helicopter Pre-flight Check List [print this page] Though flying an RC helicopter is real fun for the enthusiast who falls in love with this pastime activity, the complex machinery parts of the helicopter can lead to troubled times when precautionary measures are not put in place. The different parts of the helicopter might get worn out; damages might be caused owing to hard landings, and the flight might even end up in a crash. To prevent bodily injuries, and other sorts of damages, the RC pilot has to follow tried and tested helicopter pre-flight checkup measures. What sort of measures make up for this pre-flight check?
1.In the first place, the RC pilot has to check all the bolts and nuts that assume significance, and make sure that they are tightly held in place. The nuts as well as bolts can get loosened, owing to excess vibrations caused during the flight.
2.Before his first flight attempted during the day, the RC pilot has to check the radio and should also perform a range check. The enthusiast should ensure that there are no interferences in the vicinity, and should ensure that the throttle hold functions work with clockwork precision before flying the helicopter.
3.The ball links will have to be checked to know if they have become worn out, and make sure that they are held tightly in place. When they are not held in a tight fashion, they can get dismantled during the flight, which could pave the way for a crash.
4.Wiring is another component that demands the attention of the RC pilot, as the enthusiast should make sure that there are no cuts or breaks in wiring. One should also check to see if the servo plugs are fastened to the receiver in a secure fashion.
5.When the RC helicopter comes with a tail belt, the RC pilot should inspect the tail belt tension as a part of his pre-flight checking plan. If the belt gets loosened, it can pave the way for slippage as the enthusiast might even lose control over the tail section. But, when the belt is too tight, it can produce a negative impact on the motor and on the tail drive system parts that could lead to problems.
6.As one of the steps pertaining to helicopter pre-flight checking activity, an avid flyer should ensure that batteries are completely charged and are secured in a proper fashion. A voltmeter ought to be used to test the batteries under load. One should also check for damages that can lead to short circuits and other problems.
7.While carrying out helicopter pre-flight checking measures, the RC pilot should ensure that all the parts including batteries, gyro, BEC and ESC among other parts get mounted in a secure fashion. These parts of the RC helicopter should get mounted with the aid of zip ties, Velcro or even double side tapes to ensure that they get attached in a secure fashion.
8.The RC pilot should inspect the fly bar and blades and ensure that these parts get aligned in a proper fashion. One should also make sure that dampers are not worn out before getting ready to the fly the RC helicopter.
9.In case of the Nitro or that of gas powered helicopter, the fuel line ought to be checked to know if there are cracks or leaks, and other parts like bell, clutch and liner also deserve the attention of the flyer.
Before making an attempt to fly an RC helicopter, an enthusiast ought to carry out pre-flight check to ensure a safe and secure flying experience.
