subject: A Guide To Installing Telephone Wirings [print this page] If you are opting for a do-it-yourself telephone wiring installation, you do not have to worry. All you need is the right equipment and knowledge, and you already have the assurance that everything will be as successful as you have planned it to be. What most people do not know is that telephone wirings are easy to install, and it is essentially safe, simply for the reason that it merely involves low voltages.
If there were a difficult part of the installation, it would be the compliance with the defined standards of telephone wiring. Prior to doing the installation, it is advisable that you determine the type of telephone wiring standard that is presently used, and try to conform to that standard as much as possible.
In a basic sense, a telephone jack is a physical junction used to attach the telephone wirings to the telephone. One can affix the wiring at the back of the telephone jack, as well as connect it to the plugs by means of the front jack. The necessities that you need before you start with the installation process include a screwdriver, a telephone jack, and a wire stripper.
To begin with, it is substantial that you inspect the telephone wirings. Bear in mind that the primary color code distinguishes the negative lead of line one, which is with a red wire, as well as its positive tip, which is with the green wire. Furthermore, the ring lead of line two utilizes a yellow wire, whilst its tip lead makes use of a black one. Lastly, a blue wire is used as the ring lead of line three, and an orange wire for its tip lead.
You may also take a look at the latest Cat 5e/6 standard in order to verify the colors of the ring leads and tip leads, just in case you want to be in no doubt. Subsequently, you need to examine your telephone's jack faceplate, and situate the two terminals that link up with the two inmost pins of the jack. In a basic sense, the first terminal links to the left inmost pin, whilst the second one links to the right inmost pin.
As soon as you finish inspecting the wirings and the jack, you then need to decide on the telephone line that you opt to attach to your phone. Using your tools, cut half an inch of the insulation wirings, and slacken the terminal screws for both the first (A) and second (B) terminal. Afterward, enfold the tip wire's end around the first terminal's screw, and tighten it until it is set in its place. Do the same procedure for the ring wire on the second terminal.
When you are done with the aforementioned processes, you may plug the phone into the jack and wait until you receive a dial tone. Lastly, use your screws to attach the telephone jack to the wall.
