subject: Simple Guide Of Installing Car Speakers [print this page] there is no doubt that you have to make the issue of installing car speakers after you have buy a component stereo DVD system.nowaday,hiring a professional gay is a good and easy choice for you,but it is not a easy way for the people with a passion for vehicles and stereos.if you have a vehicle speakers updated.just following the instructions below.Remove all old speakers and their cables to avoid confusion.
In a car stereo installation, you have to determine what kind of rig youre going to put into your vehicle. If youre a beginner, its best you do a car stereo installation if its just a simple system. You may want to leave the complicated stuff to the professionals, like installing delicate equipment like LCD panels, motorized parts etc. especially if it requires the creation of custom panels and such.
Neatly clear away the old wires, grills and panels from your car. Disconnect those wires properly as well so that no electrical current is passing through them anymore. If you are planning on updating your new loudspeakers in to the same place then built-in wiring method can be used but if you have chosen a different place for your loudspeakers then you will must add some new wires in your car. Adding up new wires takes us to another pickle which is best to leave to a professional. Wires fitted from the factory in the car are always color coated which will help you in re-connecting them again. If the loudspeakers are not connectible to the old wires then you would need to cut the ends to make it compatible with the loudspeakers.
what you have to remember while the loudspeakers connected to the wire is that the negative wire will always be attached to the negative terminal of the loudspeaker and that goes for each loudspeaker whether it is rear or front. One mistake with these wires and you cannot make your car GPS stereo method work. In factory fitted wires, the black colored wire is negative and white color wire is the positive one. Tighten up these wires with the screws offered with the set of loudspeakers and do not forget to place a soft buffer between the vehicle body and the loudspeakers to reduce thumping sounds.
well,that is a simple guide of installing car DVD speaker.so if your problem can not be solved with the installation guide.make us know at www.oemcargps.com
