Board logo

subject: Solar Pool Heater [print this page]


Solar Pool Heater or photo voltaic warm water (SHW) systems comprise several improvements and several mature alternative energy technologies which have been well-established for several years. Solar pool heater continues to be broadly utilized in a holiday in Greece, Poultry, Israel, Australia, Japan, Austria and China.

Inside a "close-combined" solar pool heater system the storage tank is flat mounted immediately over the photo voltaic enthusiasts on the top. Solar pool heater, no moving is needed because the warm water naturally increases in to the tank through thermo siphon flow. Inside a "pump-circulated" system the storage tank is ground or floor mounted and it is below the amount of the enthusiasts a circulating pump moves water or warmth transfer fluid between your tank and also the enthusiasts.

You will find records of solar pool heater enthusiasts within the U.S. States dating back before 1900, composed of a black-colored tank installed on a roof. In 1896 Clarence Kemp of Baltimore, USA enclosed a fish tank inside a wooden box, thus creating the very first 'batch water heater' because they are known today. Although flat-plate enthusiasts for photo voltaic water heating were utilized in Florida and Los Angeles within the 20's there is an outburst of great interest in solar pool heater in The United States after 1960, but specifically following the 1973 oil crisis.

Solar pool heater systems are made to deliver warm water for the majority of the year. However, in the winter months there sometimes might not be sufficient solar pool heater warmth gain to provide sufficient warm water.

Solar pool heater, to be able to warmth water using solar power, a collector, frequently attached to some roof or perhaps a wall facing the sun's rays, warms working fluid that's either pumped (active system) or driven by natural convection (passive system) through it. The collector might be made from an easy glass capped insulated box having a flat photo voltaic absorber made from sheet metal mounted on copper pipes and colored black, or some metal tubes encircled by an evacuated (near vacuum) glass cylinder. In industrial cases a parabolic mirror can concentrate sunlight around the tube. Warmth is saved inside a warm water storage tank. The amount of the tank must be bigger with solar pool heater systems to be able to permit bad weather, and since the optimum final temperature for that solar panel is gloomier than the usual typical immersion or combustion heater. The warmth transfer fluid (HTF) for that absorber might be the warm water in the tank, but more generally (a minimum of in active systems) is really a separate loop of fluid that contains anti-freeze along with a corrosion inhibitor which provides warmth towards the tank via a warmth exchanger (generally a coil of copper tubing inside the tank). Another lower-maintenance concept may be the 'drain-back': no anti-freeze is needed rather all of the piping is sloped to result in water to empty to the tank. The tank isn't pressurized and it is available to atmospheric pressure.

by: Alex Shawn




welcome to loan (http://www.yloan.com/) Powered by Discuz! 5.5.0