subject: Generally Crushing, Hammer Crusher Is The Primary Choice [print this page] Crushing/Broken, there are jaw crusher, cone crusher, VSI crusher, roll crusher, generally choose the hammer crusher, but the traditional hammer crusher, there are certain shortcomings, Hongxing's mechanical technology for pc1000 mountain x 800 hammer crusher, combined with the disadvantages of the use of it in the actual production condition, puts forward several opinions for the reform:
1) article screen frame and sieve reinforcement article. Article screen frame, the article sieve used after installation location wear-resistant overlaying welding electrode welding screen frame, strengthening article wear easily work face up to 5 mm height surfacing about screen, and will be fixed in the article on screen welding article, can prevent screen frame deformation, the article screen, have fixed protection scattered. This improvement can be greatly extended article screen frame and the use time of article sieve, reduce the material cost.
2) hammer crusher rotor static and dynamic balance test, install blow, this improved balance hammer hammer crusher is to solve the vibration of important ways. Will the hammer crusher base and its drive motor backed the basis of a whole, the concrete lining, in order to enhance its ant-vibration performance and avoid vibration damage, so as to ensure the hammer party based crusher performance.
3) 160 mm frame screen extended, can decorate 4 screen, increase root article hammer crusher work area, qualified products from the grain size in time, reduce a crushing cavity smash the produce, reduce the load of the hammer, facilitate production capacity.
4) the upper frame integral structure to structure, the structure profile fraction to overhaul the rotor is very convenient, will only part of the division of hoisted out can be left to move out of the rotor.
Transformation, must pay attention to cut the upper frame, add a pair of flange, welding stress, guarantee the machine remove requirements of assembly performance. Article R520 to screen a radian R510, make the screen and hammer the clearance between the article is reduced, facilitate at the same time frame, the adjustment of the article screen when hammer, screen after wearing a frame can be enough adjust position.
jaw crusher: http://www.hxjq-crusher.com/1.html
cone crusher: http://www.hxjq-crusher.com/8.html
roll crusher: http://www.hxjq-crusher.com/7.html
roll crusher: http://www.hxjq-crusher.com/7.html
high-strength raymond mill: http://www.hxjq-crusher.com/59.html
