subject: What is router-commands.html? [print this page] Router-commands.html are nothing but commands used for specific functions of the router. If you try and count, there are a large number of commands on basic and professional level. Remembering all of them is not an easy task. Thus the frequently used commands are the only commands recollected easily. So this guide will give a list of commonly used commands for router which will help you on a daily basis.
Before starting with it, I would like to give you some list of keyboard shortcuts for router which can be very helpful:
CTRL + N For displaying the next command
CTRL + P For displaying command used previously
SHIFT + CTRL + 6 Break
The codes used are classified under different categories as per their function and usage. The following are the important router commands:
1. User Mode Commands:
disconnect
enable
ping
ping
2. Privilege Mode Commands:
clear arp-cache
configure terminal
copy running-config startup-config
debug ip packet
erase startup-config
disconnect
how interfaces ethernet 0
show interfaces loopback 0
show interfaces serial 0
3. Global Configuration Mode Commands:
access-list {permit | deny}
access-list {permit | deny}
access-list {permit | deny}
access-list {permit | deny}
dialer-listprotocol ip permit
interface fastethernet
ip default-gateway
enable password
4. Interface Sub-Configuration Mode Commands:
bandwidth
cdp enable
clock rate
compress stac in
description
dialer-group
5. Line Sub-Configuration Mode Commands:
exec-timeout [seconds]
logging synchronous
password
6. Sub-Interface Sub-Configuration Mode Commands:
frame-relay interface-dlci
frame-relay map
frame-relay map broadcast
frame-relay map broadcast ietf
ip address
7. IP Routing Protocol Sub-Configuration Mode Commands:
network
It is important to use router-commands.html accurately for desired results. Going through these guidelines would help in getting the best of your device.
