subject: Automatic Self-cleaning Filter, One Of Many Gear Intended For H2o Treatment [print this page] The Automatic self-cleaning filter is a h2o treatment equipment primarily composed of the main electromotor, filter cap, water distributor, and pneumatic-hydraulic backwashing gadgets, which functions in either of the two types: filtration and backwashing.The uncooked water runs via the purifying pump towards the incoming pipehttp://www.uvcsterilizer.com/product/automatic-self-cleaning-filter-control-box-separate.html from the filter, then via the central pipe towards the water-distributor atop the gadget. The water is also distributed and filtered though a layer. The filter layer consists of two layers, the upper coarse smokeless coal bars the passage of large particles, whilst the small ones go to the following layer of small quartz sand through a smokeless coal filter. Owing to the small diameter from the quartz, small particles will stay connected to the surface area of the other layer. The coarse sand props up filter system and distributes h2o, giving complete expression towards the perform of each layer and also the capacity of filtration. Filtered h2o runs via the filter cap to the purifying area at the bottom, and runs through the outletting pipe as the finish from the entire procedure of filtration.If pressure distinction in between the outletting and incoming pipe owing towards the massive accumulation of sludge reaches 0.05Mpa or the period of performance has exceeded 24 hours, there is been an excessive amount of accumulation of impurity and a slide in the quality of outletting h2o, subsequently necessitating backwashing. Throughout the entire process of backwashing, the incoming valve from the raw water and also the outlet valve of the filtered h2o really should be closed, and also the drainage valve from the backwashing system might be stored open till no h2o arrives out. Then , automatic self-cleaning filter release water to create the liquid degree fall below the trumpet mouth once the method is supposed to be below a common stress.Open the incoming valve from the backwashing system, and the air runs via the incoming pipe towards the under part of the device. Owing to the difference between the density of air understanding that of water, a pneumatic layer is hence placed beneath the below a part of pore boards. Residual h2o in the gadget, impelled from the difference in pneumatic pressure, runs via the filter cap, which scatters h2o evenly, towards the bottom of the filter layer upwards for automated flushing. Owing to a deficiency of pore or groove within the filter bar, once the pneumatic layer reaches a certain height, air will be pumped through the higher pore to air-rinse the filtering substances. Once the thickness from the pneumatic layer reaches a group limit, the filtering substance, given the extreme influence from the air, mutually rubs in opposition to each other. When the time span of pneumatic flushing reaches a set worth, the incoming valve should really be closed and the incoming valve of the backwashing system be opened to start the flushing of filtered h2o. The flushing water really should be drained in the drainage pipe. This ought to be followed by a positive-pressure flushing from the gadget via the incoming valve. The h2o must arrive out of the positive drainage pipe, till the outletting h2o will become clear. This concludes the process of backwashing and tends to make the device function normally.
