subject: Fuel Saver Devices for Cars [print this page] When people saw oil prices rising due to a recent boom in the economy fuel saver devices for cars were immediately introduced in the market. The main purpose of these fuel saving devices for cars was to increase the mileage of the car by increasing the fuel efficiency and decreasing the fuel intake before it reaches the car engine. This system works by dividing oxygen and hydrogen thus creating molecules that can be used as the fuel source for the engine. What petrol or gasoline do to drive an engine; oxygen and hydrogen generation do to this system by producing gases with the help of baking soda and distilled water that should be present in the system. Both baking soda and distilled water help reduce the amount of fuel needed to run a car and hence increases the car mileage.
The HHO car fuel is the most important and most useful component needed to run this system. It helps in using the hydrogen gas instead of gas produced by using petrol or gasoline. It is one of the best devices produced to reduce the use petrol and increase the mileage of vehicle. You can easily make one of those HHO car fuel cells yourself following correct instructions or under guidance, it is a hassle free process and does not need much investment, all that you need is ordinary hardware items. A simple method of electrolysis is used in the system to separate the hydrogen and oxygen molecules. You cannot use ordinary water for the process because it is not combustible. The divided hydrogen and oxygen molecules produced by the process of electrolysis are then mixed with water vapour in the combustion chamber, sucked through the air intake and ignited with the help of spark plug in the car.
Though it is a brilliant way to save fuel not many people use this system and this device because of its uncertain nature, it might get faulty and cause a major disaster at any moment. Scientists do not approve of this system either due to its unstable and underdeveloped nature or else the car manufacturers would have long ago built similar devices to increase their cars efficiency. Debates on these issues have been conducted but to have it or not to, can only be decided after knowing the benefits and drawbacks of the same.
fuel saver devices for cars can be installed just like other parts of the cars but with some technical knowledge; though buying them is not a problem but installing them sure is, make sure you have fitted the device well without any leaks or it could be very dangerous. If you're in doubt always get a professional to do it for you. Whether to install such a device or not completely depends on the choice of the owner, the device is sure a good way to save your car fuel and increase the mileage. The efficiency may be increased by modifying the internal and external design of the car and then maintaining it, but every car accepts it in its own way and the results might vary.
