subject: Only 7 Tips to make an simple FM transmitter Antenna Signal Aplifier [print this page] When TV signals become weak you will probably need to boost the signal that is received by your TV antenna with an amplifier, but what type of an amplifier do you need? HereePathChina provided many different types of distribution Antenna Signal Amplifier for you. Want to find a quality Antenna Signal Amplifier for your digital television, for Wireless camera, Transmitters, CCTV and Receivers? Browse the subcategory and purchase a cheap quality one from our online shop.
The basic purpose of an antenna is to increase the receptive power of the device it's attached to. You can make a simple FM antenna that will increase the reception of any FM receiver that has an antenna port as part of its construction. You will need a few parts from a hobby or electronic store and some experience in using a soldering iron to properly make the FM antenna--however, no electrical skill is required.
1. Measure out 3 feet of the electric wire from the spool. Cut the electric wire using the wire cutters.
2. Unscrew the black plastic insulator plug off of the 2.5mm phone plug.
3. Strip off 1/2 inch of insulation from the end of the electric wire using the wire strippers.
4. Cut a 1-inch piece of the heat shrink tubing with the scissors. Push the piece of heat shrink tubing over the end of the wire that has just been stripped.
5. Solder the end of the wire to the inner terminal on the 2.5mm phone plug that has the wire hole in it.
6. Slide the heat shrink tubing down over the inner connector. Screw the black plastic insulator back onto the the 2.5mm phone plug.
7. Plug the 2.5mm phone plug into the antenna port of the FM device. Unfurl the electric usb microphone wire.
The antenna, as shown in the diagram below, is square and is made by wrapping wire around a frame of crossing rods.
If you are an avid AM radio listener, whether it be on a old fashioned radio, a new AM/FM radio or a shortwave radio, you know it is a bit of a challenge to pick up the radio signal antenna from the AM frequency. There are a lot of things that can cause interference, but with the right radio and a good Antenna Signal Amplifier you can listen to stations from a thousand miles away.
FM transmitters are usually battery driven, but some use the cigarette lighter socket in cars, or draw their power from the device itself. They are typically used with portable audio devices such astablet PCs or MP3 players, or their mini notebook, but are also used to broadcast other outputs (such as that from a computer sound card) throughout a home or other building.
Only 7 Tips to make an simple FM transmitter Antenna Signal Aplifier
