subject: STONE CRUSHER GOOD PRACTICE [print this page] Stone Crusher Introduction Stone Crusher Introduction
Stone crushers are typically used as primary crushers, or the first step in the process of reducing rock. They typically crush using compression. The rock is dropped between two rigid pieces of metal, one of which then move inwards towards the rock, and the rock is crushed because it has a lower breaking point than the opposing metal piece.
Stone crusher movement is obtained by using a pivot point located at one end of the "swing jaw", and an eccentric motion located at the opposite end.
STONE CRUSHER GOOD PRACTICE:
1. Stone crushers should be fed a consistent rate of feed that will result in the crushing chamber being kept full at all times.
2. Deep-chambered stone crushers will have more rock-on-rock crushing while the feed is passing through, and a better nip-angle.
3. Deep-chambered jaw crushers will typically produce more cubical product and have a longer wear life from the manganese per ton processed.
4. A stone crusher should not be sized to the maximum size rock that might pass through it. It will result in buying a stone crusher that will be under-utilized, difficult to keep choke-fed, cost more than necessary, and have a much higher operating cost.
5. A stone crusher should be sized to handle 95-98% of the raw feed material, with the larger sizes being removed prior by using a grizzly.
6. Do not feed a stone crusher with rock larger than its capacity, nor with rock that is smaller than the closed-side setting. This will prevent damage to the jaw, plugging, increase the total plant production, and extend the wear life of the manganese.
Working Principle of Stone Crusher:
The motor transmits power through belt, drives the moving jaw do periodic motion to the fixed jaw surround the eccentric shaft. The angle between toggle plate and moving jaw increases when moving jaw moves up. So the moving jaw closes to the fixed jaw. The stuff will be crushed in this process. The angle between toggle plate and moving jaw decreases when moving jaw moves down, the moving jaw moves away from fixed jaw by the pulling of rod and spring, the products such as stone after crushing will be discharged from the outlet.
Our stone crusher has the features below:
1. Our stone crusher's structure is simple and our jaw crusher is easy to maintain.
2. Our stone crusher is suitable for crushing maximum,medium and minimum stones.
3. The operating principle of our stone crusher is easy to be operated.
4. Our jaw can have a smaller discharge setting.
5. The output mouth adjustment scope is big, which may satisfy the request of different user.
6. Low noise, few dusts.
7. The bearing spot uses the multi-layer labyrinth craft, to lengthen the bearing service life;
