subject: Experts Remind That The Need For Regular Inspection And Manual Brake Adjustment [print this page] Of motor vehicle traffic in Beijing now has more than 400 million vehicles, motor vehicle Drive Members of more than 5 million, will inevitably lead to excessive growth of motor vehicle traffic congestion, traffic makes a lot of complex new drivers not to drive in urban areas, especially not in the overpass on the drive. As far as I know, these newcomers are mainly afraid of the bridge sections in the park, on the initial lack of confidence, fear of sliding off after the vehicle collided with the car. The observation that not only the novice will slide cars, old drivers will slip car, in fact slip in car with car Brake Device has a lot. If the vehicle's hand brake is working properly, then the phenomenon will not slide car there. What is the parking brake
Motor vehicle parking brake is manually installed Brake , Referred to as hand brake, the vehicle stopped to stabilize the vehicle, the road to avoid vehicles parking in the slope when the slide car accident due. Common hand brake put the driver right ptosis general location, ease of use, but there are also individual vehicle parking brake will be installed in the brake pedal side.
Parking brake detection Parking brake only rear brake, which uses two pieces of metal wire rope pull rear brakes, brake to play a role. Under normal circumstances, when Handle Dip to 70% of the entire trip, when hand brake should be in the normal position of the brake, hand brake braking force is detected before the need to find this point, you can ratchet the sound to determine the number, 70% of this position is the handle of the effective work of the points.
Detection to drive the truck to the slope and the slope on the road in good condition, slam the brakes after the link into the neutral gear (Automatic Transmission On N gear), will be pulling the handle to the effective work of the point, slowly release the brake pedal later, if the vehicle does not move, indicating good performance of handbrake. In addition, also check the hand brake sensitivity, can be slow on flat road running, slowly pulling the handle and feel the hand brake sensitivity and junction, pulling handbrake will appear moving Wear and tear Therefore, the frequency of testing should not be too much.
Pull handbrake adjustment If the test is found insensitive brake, hand brake pull can be adjusted to solve, in the hand brake handle has an adjustable compensation for the following organizations. Regulation need to be demolished when the handle Decoration Cover, and then use tools to adjust the length of pull, to protect the hand brake in the best working condition.
Drive in the congestion of large cities, morning and evening peak times, vehicles less than one meter before and after the basic pitch, the slope of the overpass with a very large, novice and veteran cars will slip phenomenon occurs. Parking brake at this time is particularly important, and use it to protect the car started without slip to avoid accidents. But few owners will pay attention to check the handbrake, most vehicles will need to adjust the hand brake, the experts reminded car owners should not overlook the importance of hand brake, hand brake working poor need to be adjusted in time.
Experts Remind That The Need For Regular Inspection And Manual Brake Adjustment
