1 , starting mill , should check whether all the access door closed tight , check Crusher The jaw plate gap whether feed grain size , adjust the speed of machine should be up to approximate product size requirements . Finally according to the order of the boot .
1 , starting bucket elevator ; 2, starting jaw crusher ; 3, when there is material silo , the starting of machines; 4, start the blower ( air load started to be running after the load ); 5 Start the host , then start the instant you start the host electromagnetic vibrating feeder . Grinding work shall be started at this time . Simple sequence of operations are as follows: Start : hoist Crusher analysis machine Fan host feeder .
Second , shutdown the machine should be shut down following order :
1 , first turn off the feeder stopped feeding ;
2 , about one minute after the host ;
3, blowing off the residual powder after the cessation of sub- blowers ;
4 , the final closing of machine .
Shutdown sequence is : the host feeder Blower analysis machine .
Note : hoist transport of materials to a certain amount of silo , the first stop crusher and then to stop upgrading , the reserve feeding amount by the current changes .
5 , when the mill closed in the normal free fuel , to ensure safety, milling machine in any part of the unusual noise, or sudden load increase should immediately stop inspection , troubleshooting , in order to avoid a major accident . Then continue to boot more than material within the mill must be removed , or when the current is too large boot , the startup .
1 , milling machine using the process, there should be a fixed charge of personnel , the operator must possess the necessary skills, milling machine installed before the operation in the relevant technical training for personnel to be so understanding mill Yuanlixingneng , Familiar with the operating rules .
2 , for the milling machine work , equipment should be developed " to maintain safe operation and maintenance system " can ensure the long-term safe operation of the mill , also have the necessary maintenance tools and grease fittings .
3, milling machine used for some time, maintenance should be carried out , while roller blade grinding ring such as replacement of wearing parts for repairs , roller device in use before and after the connecting bolt nut plug should be carefully examined whether there is loose Phenomenon , whether to add a little grease .
4 , roller devices around the time more than 500 hours to replace the roller , the bearing of the roller kit must be cleaned of all , the damaged parts should be replaced , free manual manual dispensing gun oil or butter .
