subject: The Way to Install Sun Visor Monitors in Your Car [print this page] What is the sun visor monitors? It is the kind of car components which can be used to block the sun light and also monitor the sight around the driver, it is very useful for the driver when he is driving in the sun day as it can reduce the accident and help the driver to protect him and his passengers in his car. Therefore, if you have a vehicle, you can install it in your vehicle, that will help you a lot for your daily driving. In addition, car video screens are not just for the ceilings and seat backs, so you also can install monitors in the sun visor of the passenger seat. These monitors are easy to connect to an A/V selector box. But you will ask: how can I install the sun visor monitors in the car, I do not know how to do that, is it very hard for me? Do not worry about that, here I will tell you about the way to install the sun visor monitors in your car as the following:
The first step for you to install the sun visor monitors in your car is that you should open the hood and go to remove the battery cables from your car battery by using a wrench or a socket. You can check the vehicle's repair manual for the right tool size for you. That is very important for you. The second step for you to install the sun visor monitors in your car is that you should remove the original sun visors from the car unscrewing the screws in the mounting bracket with the proper screwdriver. Go to store these sun visors in order that you can replace them when you sell your car later on.
The third step for you to install the sun visor monitors in your car is that these sun visor monitors should have come preinstalled in the visor housing. You can go to align the sun visor housing mounting bracket to the proper spot and tighten the mounting screws.
The fourth step for you to install the sun visor monitors in your car is that you should route an A/V power cable to each of the sun visor monitors. You can connect the sun visor monitors separately or you can use a two-into-one A/V connector to go to connect both monitors to the same jack on the A/V selector box. You can go to connect an A/V power cable to the A/V cable on each of the sun visor monitors and use the cable ties to keep the A/V cable out of hanging for you.
The fifth step for you to install the sun visor monitors in your car is that you should reconnect the battery and then turn it on your car, you can switch the A/V selector box to the visor monitors, and they will turn on when you installed them properly. That is very important and that is certain for you, I am sure.
