subject: Make a simple and inexpensive Solar Hot Water Heater – How to build a solar water heating system [print this page] Hot water is the second highest energy costs for the typical house. A solar hot water system can reduce these costs, up to sixty percent, as it is a good economic reward. And to learn how you can build a solar hot water heating to be a great help to any family.
A solar hot water heating is usually composed of the following:
Collectors, a fluid system to move heat from the collector, its use position.
Used tank Ruleto conserve heat.
Here's how:
1st Get a hot water heater used, but make sure there are no leaks.
2nd Strip the external enclosure and isolation and the metal tank. Remove the old pipe. Remove the sediment is dried and solidified on the bottom of the tank by rolling and rocking back and forth. Rinse with water leaks during the inspection.
3rd After stripping and cleaning the bottom of sand and spray with black paint. Attractseveral layers of spray paint for maximum range and metal containers to protect from moisture and needs of its ability to protect the metal tank from moisture and increasing demands on its ability to absorb heat.
4th Fair assembly and corresponding additional plug holes. Make sure there are 2 hose fittings, a pressure relief valve and a drain plug.
5th Build a collection container that will house the size of the glass, the size of the tank and the maximum solarExposure. Attach plywood inside the structure. Caulk all interior and the wood appears to be primed and painted.
Cut 6 pieces recycled polystyrene and wedge them in the frame structure used as an insulator. Add several layers of cardboard on the polystyrene insulation to increase even more.
7th part of the curve and secure the tank in the box collector. For glasses, a recycled-glass sliding doors are used, but with double glazed glassmore preferred because of their superior insulating properties.
8th After building and painting the box, put in the tank over.
9th Secure water supply and return home in memory of the collector. Connect the overflow pipe to valve wear a positive pressure from the collector.
10th Line the inside with insulation ReflectiX to direct maximum light output over the bath and to further isolate the box. Always at the top of the lineBox with foam tape before the glass room.
