subject: Configure A D-link Router Basic Steps [print this page] Have you just recently picked up a brand new D-link router to add to your personal computer system? In these present times, most households now have more than 1 laptop or computer and most work with wireless internet connects to browse the net. Setting these devices up are not a relatively hard job, even though sometimes, the cable or broadband provider you use may have specs you must take into consideration. This will be a simple guide which is among the most typical method to configure a D-link router.
Before beginning, be sure you have all the appropriate materials required for example cables, power source plus the installation instructions plus disk as well as a power outlet. Additionally be sure that the actual cable modem is unplugged. Be certain your pc is actually turned off prior to the installation (often times current D-link routers could auto configure upon restart).
Please follow these steps:
Take the Ethernet cable which is connected from the modem to your computer and detach it from your computer. Plug that within the WAN port of the D-link router. If it is a brand new setup, and its not connected to the computer then go from the actual cable modems' Ethernet port into the router's wan port. If you would like hook up to a computer system, take another Ethernet cable and go from the actual D-link router to the port of your pc. If you are using all wireless, you don't have to use this measure.
Once the connection from your cable modem to your router is definitely attached, plug both the router and the modem back in and restart your pc. Hopefully you will observe the router LED lights blinking which means it is working plus the d-link router startup is correct, as in they are speaking to one another.
Once your computer is actually back on you will have to configure the d-link router to setup your configurations. Open Internet Explorer or maybe your preferred internet browser, and type in the universal IP address of 192.168.0.1. Look at your user guide book it gives you the first time login info.
From this point, you will need to generate a username and password, along with be certain your current firmware is current. If you use wireless, make certain to set up the SSID and be sure you create a unique name for your current router. Be sure to enable encryption so people not inside your house cannot use your wireless.
You may want to take various other actions at the time you perform your d-link router set up for example parental control, firewall, and in some cases if you wish to only allow certain computers (using a MAC address) access to your network.
