subject: Wait Until The Battery Is Running Out Before Charging [print this page] Then buy a new phone, how the battery charge is better? Because any piece of lithium batteries must be done before leaving the factory safety
All testing, the process also equivalent to activate, so you can ensure that the lithium-ion cathode material can be freely and
Without lattice collapse. So the hands of ordinary consumers to the battery, are strictly tested activation step, do not worry
Mind active.
Circulated on the Internet now charge 12 hours before the third statement of origin, before the first cell phone battery nickel metal hydride batteries,
Such as Nokia 3310, Ni-MH battery factory without activation, and the battery itself has memory effect, so in order to make electricity
Performance of the best, often requires the user to use the most when the first charge to full, then the battery is completely put End (voltage from 1.
2v into 1.0v), it can prevent the memory effect. If you start charging time is shorter if the battery is not fully excited
Live, 1000mAh battery may only charge to 900mAh, both the efficient use of battery or battery life are themselves very
Big impact.
The same method used in lithium battery what will happen to him? Because the crystal properties of lithium cobalt oxide is different from OH
Nickel, nickel hydroxide more easily than the lattice collapse of the situation there. Therefore, the process of charging, if the overcharge too long
Easy to make room for active failure of lithium cobalt oxide, plus charge will inevitably lead to temperature increases, the first great impact on the cathode material, and
And also may be dangerous. Because of this, we used lithium in the process must not be the battery is running out
Rechargeable, lithium cobalt oxide as a serious failure, shortened life expectancy. The correct way is not to wait until the battery is running out before charging
, And the battery charging instructions to complete immediately disconnect the power.
Used in mobile phone charging method is most appropriate: turned off charge off the assembly line, immediately unplug the power supply when filled, and then
