hazardous to handle due to high temperatures required for melting.
use limited to model and pattern materials that are heat resistant.
Latex
produces a very elastic, thin-walled, strong mold
shrinkage is high
molds must be supported to prevent distortion.
10 to 20 brush coats must be applied for adequate thickness, with time allowed to "dry" in between each coat, making the mold is slow and time consuming.
Silicone rubbers
excellent molds for casting resins and foams
material cost is extremely high.
Polysulfide rubbers
versatile and are especially useful for casting plaster, Hydrocal, and other water mixed cements.
can be used for casting wax candles and some limited use for resin casting.
easy to handle, non-adhesive and can be poured over clay or practically any type of model or pattern, using very simple release agents such as soap or Vaseline.
can be used to take impressions directly from a waterclay or plastelene model, so that permanent master models can then be cast in plaster or Hydrocal.
Polyurethane flexible mold compounds
limited shelf stability
"moisture conscious"
easy to handle with simple mixing ratios and good fluidity.
can be used for pouring practically any type of cementitious material, casting resin or foam formulation.
Cost of material is far below that of the silicones and appreciably lower than polysulfides.
From the standpoint of general utility and economy, the polyurethanes surpass all other types[citation needed].
Equipment and accessories
Mixing containers and stirring paddles should be of metal or plastic and always spotlessly clean, warm and dry. Use 1-inch fiber brushes cut down to 1-inch length for application of wax release agent. A regular short fiber scrubbing brush should be used for buffing wax from deep grain or fine design of model or pattern.
Sulphur Free Plastalina Clay (The Compleat Sculptor, New York City) is excellent for modeling, laying up and sealing models and dams. 1/4"-3/8" plywood should be used for mounting models. Scrap pieces can be sawed to rectangular shapes and used for straight side retaining dams.
Lightweight sheet metal, linoleum and heavy cardboard can be used for circular or irregular shaped retaining walls. Sash cord and masking tape are used to bind the walls to the model baseboard. 1/2" X 2" furring and "2 x 4's" cut to short lengths make good wedges. For plaster casting, use regular Molding or Casting Plaster
Categories: Plastics industryHidden categories: Articles lacking sources from March 2009 | All articles lacking sources | Wikipedia articles needing context from March 2009 | Wikipedia introduction cleanup from March 2009 | Articles needing cleanup from March 2009 | All pages needing cleanup | All articles with unsourced statements | Articles with unsourced statements from September 2007
