subject: Tips To Keep Your Bathroom Plumbing Running Efficiently [print this page] A toilet isn't just a place to shower, but a place for relaxation too. If your tub is clogged or the water doesn't drain well, it can be quite aggravating to say the least. To be certain that you don't have a clogged tub or a blocked drain, keep certain things under consideration so the toilet plumbing runs efficiently.
Start with running hot water down the drain at least once a week in order to keep it flowing free. Make sure that the leaky faucets are repaired to avoid any more damage to faucets and fixtures. The tubs and showers should always be fitted with strainers. The strainer will catch hair and soap chips thus preventing a clogged tub. You also need to clean these strainers regularly.
Keep a watch on the shower head - to get rid of mineral deposits on your shower head there's a straightforward home cure. Put some vinegar in a plastic carrier bag. Place the bag over the shower head. Tie it in place and leave overnight. Take away the bag in the morning and simply wipe off the mineral deposits by employing a humid fabric.
In case the holes of the showerhead get clogged with the mineral deposits present in the water, the showerhead will give you an uneven spray. You need to clean it by unscrewing the swivel ball nut. This can be done by using adjustable wrench or pliers. Next, unscrew the collar nut as well from the showerhead. Then clean the inlet and outlet holes of the showerhead gently with the help of a thin wire. In the end, flush the showerhead with clean water. In case of stubborn mineral deposits, you may consider soaking the showerhead in vinegar and also leave it overnight.
Keep the toilet bowl clean - The toilet is not your dustbin. Do not use it to flush down facial tissue, sanitary products or baby diapers. These do not dissolve and will eventually clog the lines. It is advisable to keep a trash container in all your bathrooms.
Always check the loo for any types of leaks. Keep an eye on the level of water in the tank to be sure that the water isn't overflowing thru the overflow pipe - which is the pipe in the middle of the tank having a little piece of tubes attached to it. And in case water is running into the overflow pipe, the fill valve must be altered until the water stops at virtually one in. below the apex of the overflow tube. You may also find a water level mark that'll be stamped on the side of the tank.
It's possible to test the flush valve mechanism also. Add 1 or 2 drops of food colour in the tank. After fifteen mins, check the john bowl. In case the water has changed color, it implies that either the ball or the flapper is dripping and thus, must be replaced.
Keep the Aerator clean - The water leaks from the handle or the low water pressure from the sprayer is generally due to increase of lime. This sediment causes constriction in the little openings within the sprayer head. Keep the head clean by unscrewing the aerator from the tap conscientiously using your hand. If it doesn't unscrew, put masking tape on the jaws of your pliers and loosen the aerator with these pliers. Now go on with your hand. Use vinegar to get rid of sediment and reassemble the unit.
By doing just the above, you'll be in a position to keep your toilet plumbing well looked after for a long period of time.
