subject: Installing Your Kitchen Hood In Wood [print this page] Installation of the hood in the kitchen cabinetry wood and requires some time, and tools and a champion. Design the kitchen to remove the cover and steam-based cooking odors and smoke outside the home. It also helps to protect the government over the wood stove of grease and sprinkle with oil. While you can follow the steps below to install the cover kitchen yourself, it is better to have a professional install the vent channel to the outside and electrician to install electrical wiring on the Council of Ministers.
Tools and materials
* Kitchen hood
* Hammer
* Wall cover
* Silicon dam
* Caulking Gun
* Drill
* Set screw driver drill bits
* Level
* View Drywall
* The extension of heavy rope
* Extension shaft
* Drop cloth
Has moved *
* Channel vent connector
Step 1 - Prepare Hood
Fold of the cloth so it is low and wide enough to put a lid on upside down. This protects the hood, floors and. Follow the manufacturer's instructions by removing the bottom panel, should include a filter and the channel connector and require removal. Use the wrench or screw driver remover them. Always turn power off at circuit breaker before starting any electrical projects. Locate the knockout blow that fit with the size of the duct outside vent. Tap or drive with the screw driver and hammer to kill the knockout stages.
Step 2 - Create the internal channel Hall
Link with the highest channel attached to the hood, and your assistant lift the hood in place over the range. To be installed making their mark on the bottom of the cabinet with a pencil, where is the channel. Verify that the hood is level. The return of the hood on the ground.
Aligned with the knockout channel vent mark on the bottom of the cabinet. Use a pencil to trace the opening of the vent in the cabinet. Seen digging a hole cut in the center and the search for the missing hole in the center to the circle outline and use the scroll to cut the hole.
Step 3 - Attach the Council of Ministers vent channel link
Attach the connector channel to the outside air ducts and vent hole cut for the duct hood.
Step 4 - Attach range hood
Raise the hood in the position range. Use the screws provided and attach the cover to the cabinet wood. Add Channel hood in the link channel in the cabinet above, should slide right channel in Mosul. Wiring, according to the manufacturer's instructions, generally white to black and white to black wire from the green hood and the green wire from the wall on the ground screw. Should be electrical wires coming from the lower part of the Council of Ministers. Turn once again to wave the hood, and test kitchen. Replace the filter and cover the hood.
Step 5 - Seal the region
The use of silicone plug to close the channel on the link in the government of wood.
