subject: How To Remove A Glass Tile Backsplash [print this page] Cracked your backsplash tiles and broken glass. You need to remove it so you can put up something new. But you do not really know how to go about this project. This article will list a reliable way to remove this ugly glass tiles [backsplash].
List of tools required
* A pair of leather work gloves
* A pair of safety glasses or face shield
* And a hammer
* 4-5 inch tiles and a metal wide chisel
* A bucket of water
* Sponge
* Heavy scraper
* Circular saw mill or a small corner
* Rotating diamond blade cutting tool
* Spray bottle of water
* And shovel mortar apartment
Step 1: Chisel out of glass tile
Wearing safety glasses or shield either to protect the face and your face and your eyes from flying pieces of tile and leather gloves, carefully carving a piece of glass backsplash tiles. Exactly where on the floor to hold a chisel and a hammer to the amount of force used to obtain the best results will be a matter of trial and error. If the lower-old to use, and exercise extreme caution in relation to the angle you use with the chisel. I do not want to chisel angle too far to the bottom, but you need to also make sure that you are not very parallel tiles, either. This will be also a matter of trial and error to find the appropriate angle with the chisel. If there is any piece of glass tile backsplash in which you plan to save, you will need to cut along the dividing line between the tiles will be removed, and those that will be saved. It's easier to cut along the lines of plaster and replace tiles complete. We will also look better when completion of the repair you are considering. The use of cutting tool rotating diamond blade sized correctly to make these cuts in particular. Shall be reduced to absorb the area liberally with water to keep the formation of dust on them.
Step 2: Remove the old plaster and mortar Thinset
Liberally soak the entire area that you just completely wipe you from the glass tiles. Wetland conservation area, and allow to soak for 10 to 15 minutes. Use a scraper to remove the heavy stucco and mortar shells left behind when you remove the tiles. If necessary, the use of hammer and chisel to remove the tiles large parts of thinset mortar and left behind a plaster. In any of the problem areas, soak the sponge in water and a sponge on the problem area, allowing water to completely saturate the offending piece of thinset mortar or plaster.
Step 3: Finish the preparation of the new tile surface
To maintain surface moisture, use trowel mortar to ensure a smooth flat surface to the maximum extent possible in order to be ready for whatever you have plans to replace the tile backsplash glass.
