subject: How To Remove A Brick Backsplash [print this page] Remove the brick backsplash is not an easy task. It is relatively easy to install, though different from the other tiles, but removing the brick [backsplash] does not require the hands soft. There is no way to remove the sediment brick bricks without damaging or causing damage to the wall behind it. Fu is much easier to remove the brick but the real building block is installed using an adhesive force. The following article will guide you on how to remove the brick backsplash with minimal damage as possible.
Tools and materials required:
* Drop cloth
* Eye protection
* Hammer
* Chisel
* Small pry bar
* Face protection
* Utility knife
Void *
* Dremel Tool
Annex Sanding
Work Gloves *
Step 1 - Prepare the area
And remove the brick backsplash create a lot of dust and debris. Protect yourself and your home is very important. Given the enormous amount of debris that will be created will need to cover the upper floor and control your cloth drop. You should always wear your eye protection, and a face mask and gloves while working. Place masking tape on the light switches and outlets that may be on backsplash. You can remove the face plates and turn the power off, but if you want to cover still have the masking tape. This will prevent dust and debris from entering the port or switch boxes.
Step 2 - the fat to accumulate in the brick backsplash
Excavation block and remove it, but also hurt the wall. The trick is to ease enough to brick in order for you to be able to keep them away from the wall. First, use the dremel with a sanding attachment to remove the top layer of plaster or mortar shells. To continue to remove sediments in this way until you have the advantage of brick above the plaster. The benefit of using a knife and cut the line through the middle of plaster or mortar shells. This will take some time because the material is very difficult to cut through. I want to be able to create enough of a deep cut in a mortar to allow the party to sit chisel securely. Insert chisel in the groove with my utility knife and starts ticking. Plaster and mortar begins to lose come, breaking and shattering. Remove as much of the bricks as possible. You need to be able to get closer to the wall behind the brick backsplash possible.
Step 3 - Remove Bricks
Will be almost impossible to remove all the plaster or mortar. Use a tool dremel again to the bottom of the sand plaster or mortar on the base of brick. Place the carved brick wall and a hammer to meet under the tile. No hammer is very difficult to remove the bricks, because in this corner of the wall has come with it. Now you can switch to the small pry bar. Work under the brick and rummage on the wall. Continue to remove the brick backsplash so all of the bricks are gone. Clean the area with a vacuum.
