subject: How To Laminate Cabinets In 6 Steps [print this page] For laminate cabinets in your kitchen, and easier, more cost and time effective solution to the use of self-adhesive sheet membranes. The results can be beautiful, and at much lower cost than replacing cabinets.
Materials needed:
Screwdriver
HUMMER
sand paper
Putty
Tack Cloth
reduction in favor of the end of the
Adhesives & Wood
Completion of the nails
Self-adhesive laminate
Laminate Veneer
Step 1 - Remove the doors, templates, equipment
Open the door a little to the Council of Ministers and then use a screwdriver to remove the stop. You can remove the molding with a hammer branch. Simply pry off the stop, and being nice so as not to break the cabinets themselves. Maintain the hardware and screws together if you plan to re-use devices. If there is loose or peeling finishes on surfaces you plan to laminate, you have to sand and clean to remove them. Use putty to fill any scratches or the Great Depression. Any paste it usually takes about an hour to dry.
Step 2 - Sand and clean the surfaces
The use of a fine, 150 grit, and sand paper and lightly scuff the surface where you plan to install laminate. Reduction in the use tack cloth, remove all the sawdust particles from surfaces, then clean them with a piece of cloth in a solution of water and dishwashing soap. Use a damp cloth barely, not soaking. If you have wax in your cupboards, remove it with ammonia.
Step 3 Install the cut for the end of the team
Cut to fit the end plates and slices of crust that comes in containers of 5-10 and easily "cut to fit" your cabinets. Use cut to fit a piece of plywood panels to cover the end of your cabinets. Measure, then cut to pieces by size. Use wood glue and nails to attach it to end decisively. Sand with 150 grit sandpaper and sand the edges of plywood so that it is flush with the front in the government. This sheet will stick to your cabinets and the expansion of segments of age.
Step 4 to install self-adhesive laminate to the inside edges
Use a sharp knife utility, rotary cutters, or scissors and cut the laminate into slices. Tapes allow curvature and keep inflation from chips. Additional half-inch pieces, both in length and width so that you can reduce the flow to the Treasury after it is installed. Cover the vertical cut, stairs, first, and then cover the horizontal pieces (rails) II.
Beginning with the top of the stile, laminate cabinets by peeling back a small part of the paper support. Disclose as much of the crust allowed to install the tape on the window to the inside. Must be placed the upper edge of the Gaza Strip so that the box with the upper part of the Open. As you slowly peel off the support, press lightly and smoothly on the crust and keep it aligned correctly. It is almost impossible to move the crust after its application, so make sure you do it right the first time. After you do the stairs inside, is within the bars. Use a knife to cut the edges even inside.
Step 5 Application of membrane-to-face frame
Ranging from the stairs, once again to the line of crust carefully. Anchor up, and make sure they hunt box. Then, through the installation of laminate cabinets carefully the crust on the face of the Council of Ministers. Maintain the overlap even on both sides of the stile. Even if one crust is uneven, it will ruin the entire cabinet. Repeat another stile, then apply the laminate over the railway line in the same way.
Step 6 Trim
Use the utility knife carefully for the trip extra sharp and overlap of the holes. Make sure there is a steady hand at this point.
Congratulations, you wrapped your cabinets! It is a simple project to add a little flair to any room with cabinetry.
