How To Operate The Humidor

When someone first purchases a new cigar humidor there are a few mandatory steps to preparing it for effective use

. For example, the accurate measuring of the humidity level inside of the box is required, as is the preparation of the Spanish cedar wood if it is too dry. The water used for any ongoing processes must always be distilled water, and this is for several important reasons.

For example, the hygrometer must be calibrated according to the manufacturer's instructions. If this is not done then the device is not going to accurately document the current moisture level of the air inside of the box.

Where the humidifier is concerned, the contents must be limited to two specific substances - PG (Propylene Glycol) and distilled water. While most cigar enthusiasts will automatically obtain the PG without question, many wonder why distilled water is so necessary and why ordinary tap water cannot suffice. The answer is actually very simple - tap water and even filtered or bottled waters will all come with additional minerals or chemicals. These substances will then interfere the PG and its important functions.

The first thing to do is to take the hygrometer and insert it per the manufacturer's directions inside of the box. Most meters need to be properly calibrated in advance of their use, and this too must be done according to the instructions. When the meters are new, they usually demand a full seven to ten days to become balanced, and it is important to have the patience and allow this time to pass. After a week has gone by the reading for the box can be taken. If it is below 70% the box will not keep cigars at optimal conditions, and the humidifier must be added.

In addition to being free of particles that can interfere with the humidifier, distilled water is also germ and bacteria free too. This makes it a good solution to use as a preliminary spray or rub on the interior surface of the humidor as well. For example, many new humidors may be sold as "pre-seasoned" but are far too dry upon arrival. The owner can simply take a brand new sponge and a bottle of distilled water and carefully wipe down the surface to rehydrate it. Once this is done they can take a properly calibrated hygrometer and leave the box in place for a few days. Should the humidity levels remain too low they can repeat the wipe down process until the wood has absorbed enough water to maintain a steady level of humidity.

by: Ryder Sabot

POST COMMENT

Car Hire York! The Benefits of an Anti Snoring Mouthpiece Genelec 8250a Beer Pong News Want To Sell Your Car? Diwali Sarees: All About Dazzle What Is Hcg Made Of? Facts About Asthma Attacks What is Your Favorite Positive Feeling? Is All This Bullying Stuff Just A Lot Of Bull...? The Incredible Elephant Hypnotist Phantasm A Burning Issue Caused By Burning? Super Sea Veg - Conduit To The Fountain Of Youth?