To update the TOYOTA Navigation DVD, you need to use an overhead mounting bracket thane make the installation process much easier and convenient
. A DVD navigation system enable drivers find any points of interest or street name around the county. The multi-functional audio video also allows you watch movies and receive the radio when you have rest in the car. So it is important to learn some basic skill to update a car DVD play. Now we would like to direct you step by step.
Step1:
Use a flathead screwdriver to loosen the distance between the ceiling and the dome light. When the dome light is loose enough, you can remove it from the ceiling of car and get ready to install the car navigation system.
Step 2
Remove the wire harness from the back of the dome light. Tuck the wire harness into the ceiling hole and place the bracket over the hole. Cut the headliner around the bracket by tracing it with a carpenters knife. Remove the bracket and discard the headliner. Thread the wire harness through the bracket.
Step 3
Hold the bracket back to the ceiling over the area with the removed headliner. Having the bracket sit flush against the ceiling and not on the headliner reduces vibration in the DVD unit. Drill through each corner of the bracket into the ceiling using a machine tap drill bit. Do not drill through the ceiling.
Step 4
Install the mounting screws on the drilled holes and plug the power plus into the navigation DVD. Position the DVD player on to the bracket and make sure it locks into place.
Warming & Tips
Avoid touching the underside of either GPS disc. Smudges caused by oil on the hands will heat when the disc is inserted into the car. While this might not cause immediate problems, it can create reading errors once the car is being driven.